SsangYong Korando II (1996-2006 year). Manual — part 394
SSANGYONG MY2002
7D-20 FATC-HAVC
KAA7D270
KAA7D280
KAA7D290
KAA7D300
Sun load Sensor
Sun load sensor is a photo diode that detects lights.
Resistance of diode can be measured as current by
using multimeter according to increasing sun loads.
1. Check current on the circuits between the sun load
sensor and the airconditioner control unit.
2. Turn the ignition switch to ON position and check
that voltage between No. 13a terminal of the sun
load sensor and vehicle ground is 5V.
3. Measure current between No. 13a terminal of the
sun load sensor and No. 11 terminal of the control
unit and check it is as shown in the below graph.
4. If current value is out of specification, replace the
sun load sensor.
FATC-HAVC 7D-21
SSANGYONG MY2002
KAA7D310
Fault : intake (recirculation/fresh air) door inoperative
Remove the glove box.
Check No. 24 fuse (15A) in the box.
Yes
No
Check that it operates toward each direction after
connecting the battery to the 6C terminal of intake
actuator and ground 6A & 6B to the body.
Wiring side connector
Intake actuator is normal.
Yes
Repair and replace the intake actuator.
No
Check intake actuator linkage and door for
proper operation and repair if necessary.
Disconnect 20-pin connector from the airconditioner
control unit.
Check current between the intake actuator (6A, 6B)
and the airconditioner control unit (6,7).
Is there current?
Yes
Repair open wire between the intake actuator
and the control unit.
No
Replace the good control unit and re-check. If no
fault, replace the control panel.
Measure voltage between 6c terminal positive pole
(+) and body (-).
Measured voltage is 12V.
Turn the ignitin switch OFF and disconnect harness
of the intake actuator.
Disconnect 3-pin connector of the intake mode
actuator and turn the ignition switch to ON position.
SSANGYONG MY2002
7D-22 FATC-HAVC
Fault : air flow does not change toward panel side.
Remove the center panel of the instrument panel.
Measure voltage between 8I terminal positive pole
(+) and body (-).
Measured voltage is 12V.
Check No. 24 fuse (15A) in the fuse box.
Turn the ignition switch OFF and disconnect harness
of the mode actuator.
Yes
No
Disconnect 8-pin connector of the mode actuator and
turn the ignition switch to ON position.
Check that it operates toward each directions when
ground is connected to terminal (8J, 8H, 8F, 8D, 8B)
of the mode actuator alternatively.
Mode actuator is normal.
Yes
Repair and replace the mode actuator.
No
Check the intake actuator linkage and door
for proper operation and repair if necessary.
Disconnect 20-pin connector from the airconditioner
control unit.
Check current between the mode actuator (8J, 8H,
8F, 8D, 8B) and the airconditioner control unit (11,
12, 13, 14, 15).
Is there current?
Yes
Repair open wire between the mode actuator
and the control unit.
No
Replace the good control unit and re-check. If no
fault, replace the control panel.
KAA7D350
SECTION 8A
SEAT BELTS
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must be in B unless otherwise
noted.
TABLE OF CONTENTS
Description and Operation . . . . . . . . ... 8A-2
Driver Seat Belt Warning . . . . . . . . . .. 8A-2
Three-Point Front Seat Belt With Pretensioner . ... 8A-2
Three-Point Rear Outboard Seat Belt . . . . . 8A-2
Two-Point Lap Rear Center Seat Belt . . . . . 8A-2
Operational and Functional Checks . . . . . .. 8A-2
Child Seat Tether Anchor . . . . . . . . . . 8A-2
Component Locator . . . . . . . . . . . . 8A-3
Front Seat Belt . . . . . . . . . . . . . . 8A-3
Rear Seat Belt . . . . . . . . . . . . . . 8A-4
Repair Procedures . . . . . . . . . . . ... 8A-5
On-Vehicle Service . . . . . . . . . . . . . 8A-5
Three-Point Front Seat Belt With Pretensioner . ... 8A-5
Front Seat Belt Height Adjuster . . . . . . . 8A-6
Three-Point Rear Outboard Seat Belt . . . . . 8A-6
Two-Point Lap Rear Center Seat Belt . . . . . 8A-7
Child Seat Tether Anchor . . . . . . . . . . 8A-7
Specifications . . . . . . . . . . . . . ... 8A-8
Fastener Tightening Specifications . . . . . ... 8A-8
Schematic and Routing Diagrams . . . . . ... 8A-9
Seat Belt & Tension Reducer . . . . . . . ... 8A-9
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст