SsangYong Korando II (1996-2006 year). Manual — part 183
OM600 ENGINE MECHANICAL 1B3 -- 181
DAEWOO MY_2000
Tools Required
102 589 00 15 00 Drift
102 589 12 15 00 Drift
Replacement Procedure
1. Completely drain the coolant.
2. Remove any parts which impede access.
(Example : transmission, injection pump)
3. Place the screwdriver to the deepdrawn edge of the
core plug and pull forward and then rotate 90_.
4. Pull out the core plug with pliers.
5. Thoroughly clean the sealing surface and apply Loc-
tite 241.
6. Install the new core plug by using a drift.
Drift 102 589 00 15 00 (F34)
Drift 102 589 12 15 00 (F17)
7. Install the removed parts and fill the coolant.
Notice
The adhesive must be allowed to harden for about
45 minutes before filling of coolant.
8. Warm up the engine and check the coolant for leaks.
1B3 -- 182 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
FACING CRANKCASE CONTACTING SURFACE
1 Crankcase
2 Crankcase Contacting Surface
Y Height (crankcase upper surface -- crankcase
lower surface)
B Longitudinal Direction
C Transverse Direction
H Chamfer Height
b Chamfer Angle
Service Data
Height ’Y’
Min. 299.62 mm
Permissible unevenness of contacting surface
In longitudinal direction (B)
0.06 mm
Permissible unevenness of contacting surface
In transverse direction (C)
0.06 mm
Permissible roughness upper contacting surface
0.0006 -- 0.0016 mm
Permissible variation of parallelism of crankcase upper
surface to lower surface in longitudinal direction
0.05 mm
Pi t
t
i
t TDC t
k
f
Max.
0.965 mm
Piston protrusion at TDC to crankcase upper surface
Min.
0.735 mm
OM600 ENGINE MECHANICAL 1B3 -- 183
DAEWOO MY_2000
OIL GALLERY STEEL BALL
Preceding Work :
Removal of cooling fan
Removal of the water pump housing
Removal of the flywheel and driven plate
1 Steel Ball
φ15mm
. . . . . . . . . . . . . . . . . . . . . . . . .
2 Screw Plug
Loctite 241, 50N∙m
. . . . . . . . . . . . .
Notice
The screw plug (2) has to be installed as a repair
solution if the steel ball (1) is leaking.
1B3 -- 184 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
3 Steel Ball
φ17mm
. . . . . . . . . . . . . . . . . . . . . . . . .
4 Seal
5 Screw Plug
50N∙m (37 lb-ft)
. . . . . . . . . . . . . . . .
Notice
The seal (4) and screw plug (5) have to be installed as a
repair solution if the steel ball (3) is leaking.
Tools Required
601 589 08 15 00 Drift
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст