SsangYong Korando II (1996-2006 year). Manual — part 114

1F2 -- 36 M161 ENGINE CONTROLS

DAEWOO MY_2000

Spark Plug Cable Resistance Inspection

1. Turn the ignition switch “OFF” position.
2. Disconnect the spark plug cables Refer to Section 1E1, Engine electrical.
3. Measure the spark plug resistance using a multimeter.

Specified Value

1.8 ~ 2.2 kΩ

Notice: Replace the spark plug cable if the measured values is out of the specified values.

M161 ENGINE CONTROLS 1F2 -- 37

DAEWOO MY_2000

BLANK

1F2 -- 38 M161 ENGINE CONTROLS

DAEWOO MY_2000

SYSTEM VOLTAGE

KAB1F190

Failure

Code

Description

Trouble Area

Maintenance Hint

08

System voltage too low

Malfunction in recognition of

system source voltage.
Less than minimum 8 volts in

2,000 rpm below, or less than

10 volts in 2,000 rpm above.

D

Monitoring the actual battery voltages

through the scan tool

D

Inspection the Engine Control Module

(ECM) pin 12, 11, 10, 5 about short

circuit or open with bad contact

D

Inspection the over voltage protection

relay

D

Inspection the battery

D

Inspection ECM

M161 ENGINE CONTROLS 1F2 -- 39

DAEWOO MY_2000

IGNITION SWITCH

KAB1F200

Failure

Code

Description

Trouble Area

Maintenance Hint

71

Starter signal

recognition failure

When not detection of starter

signal

D

Inspection the Engine Control Module

(ECM) pin 2 circuit short or open with

bad contact

D

Inspection ECM