SsangYong Korando II (1996-2006 year). Manual — part 454
SSANGYONG MY2002
9O-2 BUMPERS AND FASCIAS
DESCRIPTION AND OPERATION
BUMPERS
The bumper systems are designed to sustain a collision
into a fixed barrier at 8 km/h (5 mph) without damage.
BUMPERS AND FASCIAS 9O-3
SSANGYONG MY2002
COMPONENTS LOCATOR
BUMPERS AND FASCIAS
1 Front Bumper Assembly
2 Pad
3 Fog Lamp Mounting Bracket
4 Side Mounting Bracket
5 Rivet
6 Bolt
7 Front Nudge Bar Assembly
8 Side Support Bracket
9 Front Bumper Assembly
10 Rivet
11 Protection Tape
12 Rear Bumper Spacer
13 Side Bracket
14 Nut
15 License Lamp Assembly
KAA9O010
SSANGYONG MY2002
9O-4 BUMPERS AND FASCIAS
KAA9O030
KAA9O040
2. Remove the front bumper with the bolts.
Installation Notice
•
Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use
the correct fasteners to prevent premature
corrosion.
3. Remove the front bumper fascia.
4. Installation should follow the removal procedure
in the reverse order.
KAA9O020
ON-VEHICLE SERVICE
UNIT REPAIR
FRONT BUMPER FASCIA
Removal and Installation Procedure
1. Remove the side support bracket nuts.
Installation Notice
•
Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use
the correct fasteners to prevent premature
corrosion.
REPAIR INSTRUCTIONS
Tightening Torque
11 N•m (97 lb-in)
Tightening Torque
117 N•m (154 lb-ft)
BUMPERS AND FASCIAS 9O-5
SSANGYONG MY2002
KAA9O050
REAR BUMPER FASCIA
Removal and Installation Procedure
1. Remove the mud guard. Refer to Section 9M,
Exterior Trim.
2. Remove the rear bumper with the bolts.
3. Remove the rear bumper fascia from the rear
bumper.
Installation Notice
•
Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use
the correct fasteners to prevent premature
corrosion.
4. Installation should follow the removal procedure
in the reverse order.
KAA9O060
FRONT BUMPER IMPACT BAR
Removal and Installation Procedure
1. Remove the front bumper fascia. Refer to Front
Bumper Fascia in this section.
2. Remove the nuts with the front bumper impact bar.
Installation Notice
•
Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use
the correct fasteners to prevent premature
corrosion.
3. Installation should follow the removal procedure
in the reverse order.
Tightening Torque
29 N•m (21 lb-ft)
Tightening Torque
117 N•m (154 lb-ft)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст