SsangYong Korando II (1996-2006 year). Manual — part 455
BUMPERS AND FASCIAS 9O-7
SSANGYONG MY2002
Front Bumper Fascia Scrivet
Front Bumper Mounting Bolts
Front Bumper Im Pact Bar Nuts
Rear Bumper Fascia Nuts
Side Support Bracket Nuts
Application
N•m
Lb-Ft
Lb-In
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
11
117
117
29
11
-
154
154
21
-
97
-
-
-
97
SECTION 9P
DOORS
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless
otherwise noted.
TABLE OF CONTENTS
Description and Operation . . . . . . . . ... 9P-2
Power Door Locks . . . . . . . . . . . . 9P-2
Power Windows . . . . . . . . . . . . ... 9P-2
Door Lock Striker . . . . . . . . . . . . . 9P-2
Components Locator . . . . . . . . . . . 9P-3
Doors . . . . . . . . . . . . . . . . .. 9P-3
Repair Instructions . . . . . . . . . . . . 9P-4
On-Vehicle Service Unit Repair . . . . . . . . 9P-4
Door Glass Run . . . . . . . . . . . . ... 9P-4
Door Side Opening Weatherstrip . . . . . . .. 9P-4
Door Lock Striker . . . . . . . . . . . . . 9P-4
Door Lock Striker Adjustment . . . . . . . ... 9P-5
Front Door Lock . . . . . . . . . . . . ... 9P-6
Inside Door Handle . . . . . . . . . . . .. 9P-7
Outside Door Handle . . . . . . . . . . ... 9P-7
Door Lock Cylinder . . . . . . . . . . . .. 9P-7
Power Window Regulator . . . . . . . . . . 9P-8
Front Door Assembly . . . . . . . . . . ... 9P-8
Tail Gate Assembly . . . . . . . . . . . . 9P-8
Door Hinge . . . . . . . . . . . . . . .. 9P-9
Door Hold Open Link . . . . . . . . . . ... 9P-9
Outside Channel Molding . . . . . . . . . . 9P-9
Door Weatherstrip . . . . . . . . . . . . 9P-9
Door Seal Trim . . . . . . . . . . . . ... 9P-10
Specifications . . . . . . . . . . . . . . 9P-11
Fastener Tightening Specifications . . . . . . 9P-11
Schematic and Routing Diagrams . . . . . . 9P-12
Central Door Locks System . . . . . . . . 9P-12
Power Windows . . . . . . . . . . . . . 9P-13
SSANGYONG MY2002
9P-2 DOORS
DESCRIPTION AND OPERATION
POWER DOOR LOCKS
The power door locks use a solenoid that is contained
in each door lock assembly. The door locks are
activated by the actuator on the inside door handle or
by the lock cylinder on the driver’s side door only.
When the driver’s side door is locked or unlocked by
the actuator or lock cylinder, all doors are locked or
unlocked accordingly.
POWER WINDOWS
The power windows are controlled by electrical
switches on the door trim center upper panel and are
operated by a motor at each window regulator. The
windows are lowered by pressing the switch and are
raised by pulling up on the switch. The window will
stop movement when the switch is released or when
the windowis completely open or closed.
DOOR LOCK STRIKER
The front door lock strikers each consist of a striker
with two screws threaded into a floating cage plate in
the B-pillars. The door lock fork snaps over and engages
the striker.
SSANGYONG MY2002
9P-4 DOORS
DOOR LOCK STRIKER
Removal and Installation Procedure
1. Remove the screws and the door lock striker.
Installation Notice
•
Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use
the correct fasteners to prevent premature
corrosion.
2. Installation should follow the removal procedure
in the reverse order.
KAA9P020
ON-VEHICLE SERVICE
UNIT REPAIR
DOOR GLASS RUN
Removal and Installation Procedure
1. Lower the window.
2. Remove the glass from the door.
3. Remove the front door glass run.
4. Installation should follow the removal procedure
in the reverse order.
REPAIR INSTRUCTIONS
KAA9P030
DOOR SIDE OPENING
WEATHERSTRIP
Removal and Installation Procedure
1. Remove the side opening weatherstrip.
2. Installation should follow the removal procedure
in the reverse order.
Tightening Torque
9.8 - 18.62 N•m
(7.23 - 13.74 lb-ft)
KAA9P040
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст