SsangYong Korando II (1996-2006 year). Manual — part 10
1B1 -- 6 M162 ENGINE MECHANICAL
DAEWOO MY_2000
Special Tools Table (Cont’d)
DW110 -- 100
Valve Tappet Remover
M162 ENGINE MECHANICAL 1B1 -- 7
DAEWOO MY_2000
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
ENGINE ASSEMBLY
1B1 -- 8 M162 ENGINE MECHANICAL
DAEWOO MY_2000
Removal & Installation Procedure
1. Disconnect the negative terminal of battery.
2. Remove the hood.
3. Remove the under cover.
Installation Notice
Tightening Torque
28 -- 47 NSm (21 -- 35 lb-ft)
4. Disconnect the mass air flow sensor meter connec-
tor.
5. Disconnect the mass air flow sensor meter from the
air filter housing.
6. Remove the intake air duct mounting nuts.
Installation Notice
Tightening Torque
9 -- 11 NSm (80 -- 97 lb-in)
7. Remove the air cleaner cover. Remove the mounting
bolts and air cleaner housing and element assembly.
8. Loosen the radiator drain cock and drain the coolant.
Notice: Open the coolant reservoir cap.
M162 ENGINE MECHANICAL 1B1 -- 9
DAEWOO MY_2000
9. Loosen the cylinder block drain plug and then drain
the coolant completely.
Installation Notice
Tightening Torque
30 NSm (22 lb-ft)
Notice: Replace the seal before installation of the drain
plug.
10. Remove the cooling fan shroud. Refer to Section
1D1, Engine Cooling.
11. Disconnect the each hose from radiator.
12. Remove the upper mounting bolts of radiator and
then remove the radiator.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст