SsangYong Korando II (1996-2006 year). Manual — part 11
1B1 -- 10 M162 ENGINE MECHANICAL
DAEWOO MY_2000
13. Remove the hydraulic pipe of power steering.
Notice: Completely drain the oil.
14. Discharge the refrigerant from A/C system, and dis-
connect the discharge pipe and suction pipe from
the compressor. Refer to Section 7B, Manual Con-
trol Heating, Ventilation, and Air Conditioning Sys-
tem.
15. Remove the fuel feed and return line.
Notice: Before removing the fuel lines, release the pres-
sure in the fuel system.
Installation Notice
Tightening Torque
21 -- 25 NSm (15 -- 18 lb-ft)
16. Disconnect the terminals from the generator.
M162 ENGINE MECHANICAL 1B1 -- 11
DAEWOO MY_2000
17. Disconnect the terminals from starter motor and re-
move the starter motor.
18. Disconnect the engine main harness ground.
19. Disconnect the engine ground wire.
20. Disconnect following sensors connector.
D
HFM sensor.
D
Coolant temperature sensor.
D
2 knock sensors.
D
Camshaft and crankshaft sensors.
21. After removing the ignition coil cover, disconnect the
ignition coil connector.
22. Remove the harness cover and disconnect the 6 in-
jection valve connectors. Disconnect the main har-
ness.
1B1 -- 12 M162 ENGINE MECHANICAL
DAEWOO MY_2000
23. Separate the hose toward engine from canister
purge solenoid valve.
24. Remove the canister. Refer to Section 1F1, Engine
Control.
25. Remove the automatic transmission oil cooler line
retaining bolts from the automatic transmission side
and oil pan side
26. Remove the automatic transmission oil cooler line
retaining bolts from engine side and oil pan side.
27. Separate the vacuum hose for brake booster.
28. Separate the other vacuum hoses.
29. By rotating the crankshaft from the front of engine,
remove the 6 torque converter mounting bolts from
the engine ring gear plate.
Installation Notice
Tightening Torque
42 NSm (31 lb-ft)
M162 ENGINE MECHANICAL 1B1 -- 13
DAEWOO MY_2000
30. Remove the exhaust manifold and exhaust pipe.
Installation Notice
Tightening Torque
30 NSm (22 lb-ft)
31. Remove the transmission. Refer to Section 5A, Au-
tomatic Transmission.
32. Install a chain to the bracket of engine, by using a
hoist or crane.
33. Remove the engine mount nuts.
Installation Notice
Tightening Torque
70 NSm (52 lb-ft)
34. Carefully separate the engine assembly from the ve-
hicle.
35. Installation should follow the removal procedure in
the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст