SsangYong Korando II (1996-2006 year). Manual — part 459
ROOF 9Q-3
SSANGYONG MY2002
COMPONENTS LOCATOR
ROOF
KAA9Q010
1 Inner Sliding Sun Roof Assembly
2 Sun Roof Body Mounting Bracket
3 Drain Hose Rear Grommet
4 Sun Roof Motor Spanner
5 Mounting Clip
6 Mounting Bracket
7 Mounting Bracket assembly
8 Sun Roof Mounting Bracket
9 Drain Front Hose
10 Drain Rear Hose
11 Sun Roof Module Assembly
SSANGYONG MY2002
9Q-4 ROOF
KAA9Q030
SUN VISORS
Removal and Installation Procedure
1. Remove the screws and the sun visor from the
headliner.
KAA9Q020
UNIT REPAIR
FORMED HEADLINER
Removal and Installation Procedure
1. Remove the front and rear upper seat belt anchor.
Refer to Section 8A, Seat Belts.
2. Remove the assist handles. Refer to Section 9G,
Interior trim.
3. Remove the sun visors. Refer to “Sun visors” in
this section.
4. Remove the power sunroof control switch. Refer
to “Power Sunroof Control Switch” in this section.
5. Remove the interior courtesy lamp. Refer to Section
9B, Lighting system.
6. Remove the left and the right A-pillar trim panel.
7. Remove the upper quarter trim panel. Refer to
Section 9G, Interior Trim.
8. Remove the child seat anchor. Refer to Section
9H, Seats.
9. Remove the headliner.
10. Installation should follow the removal procedure
in the reverse order.
2. Remove the screw and the sun visor support from
the headliner.
3. Installation should follow the removal procedure
in the reverse order.
KAA9Q040
SECTION 9R
BODY FRONT END
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless
otherwise noted.
TABLE OF CONTENTS
Description and Operation . . . . . . . . ... 9R-2
Body Front End . . . . . . . . . . . . . 9R-2
Components Locator . . . . . . . . . . . 9R-3
Body Front End . . . . . . . . . . . . . 9R-3
Repair Instructions . . . . . . . . . . . . 9R-4
On-Vehicle Service Unit Repair . . . . . . . . 9R-4
Lubrication . . . . . . . . . . . . . . .. 9R-4
Fasteners . . . . . . . . . . . . . . . 9R-4
Anticorrosion Materials . . . . . . . . . . . 9R-4
Cowl Vent Grille . . . . . . . . . . . . ... 9R-5
Hood . . . . . . . . . . . . . . . . ... 9R-5
Hood Hinges . . . . . . . . . . . . . ... 9R-6
Hood Gas Spring . . . . . . . . . . . . . 9R-6
Specifications . . . . . . . . . . . . . ... 9R-7
Fastener Tightening Specifications . . . . . ... 9R-7
SSANGYONG MY2002
9R-2 BODY FRONT END
DESCRIPTION AND OPERATION
BODY FRONT END
This vehicle has a unitized body with a frame assembly
supporting the engine and the transaxle. The fender
panels and the radiator support are also integral parts
of the body.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст