SsangYong Korando II (1996-2006 year). Manual — part 173
OM600 ENGINE MECHANICAL 1B3 -- 141
DAEWOO MY_2000
4. Remove the bolt and then remove the camshaft
sprocket.
Notice
During removal, be careful not to drop the sprocket
with chain. Remove the chain carefully and then pull
out the sprocket.
5. Remove the chain tensioner.
6. Remove the camshaft bearing cap bolts according
to the removal order.
Notice
Remove the camshaft bearing cap bolts of 1(dark
arrow) first and then remove the bolts of 2 (light ar-
row) one revolution in stages until the counter--pres-
sure is released. In order to avoid damaging the
camshaft, it is essential to adhere to the removal or-
der for the camshaft bearing caps.
OM 662LA
OM 661LA
1B3 -- 142 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
7. Remove the camshaft bearing cap.
8. Pull off the camshaft.
Notice
Be careful not to miss front locking washer.
9. Pull out the locking washer.
Notice
Check the condition of locking washer and replace if
necessary.
Installation Procedure
1. Insert the locking washer.
2. Check the valve tappet and ensure that tappet
moves smoothly.
3. Coat the camshaft with oil and install the camshaft
onto the cylinder head so that the TDC marking (ar-
row) is positioned upward vertically.
4. Install the camshaft bearing caps according to
markings(1, 2, 3 etc.).
OM600 ENGINE MECHANICAL 1B3 -- 143
DAEWOO MY_2000
5. Tighten the camshaft bearing cap bolts acccording
to installation order.
Tightening Torque
25 N∙m (18 lb-ft)
Notice
Tighten the No. 1 bolts (light arrow) by one revolu-
tion in stages first and then tighten the No.2 bolts
(dark arrow).
OM 662LA
OM 661LA
6. Install the camshaft sprocket to be aligned the mark-
ings of the camshaft / camshaft bearing cap (arrow).
Notice
Align the alignment marks on the timing chain and
sprocket.
7. Tighten the camshaft sprocket bolt.
Tightening Torque
25 N∙m (18 lb-ft) + 90_
1B3 -- 144 OM600 ENGINE MECHANICAL
DAEWOO MY_2000
Notice
If max. length ’L’ of the 12--sided bolt exceeds
53.6mm, replace it.
8. Install the chain tensioner.
Tightening Torque
80 N∙m (59 lb-ft)
Notice
Replace the seal.
Before installation, by pumping in the oil approx. 10
times, fill the oil.
9. Remove the engine lock.
10. Check the TDC marking of OT on the crankshaft.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст