SsangYong Musso. Manual — part 436
FRONT DRIVE AXLE 3A-13
14. Remove the drive shaft mounting bolts and remove the
drive shaft.
Installation Notice
Tightening Torque
45 - 60 Nm
15. Installation should follow the removal precedure in the
reverse order.
Observe the tighening torque and sequence.
3A-14 FRONT DRIVE AXLE
1 Axle Mounting Bracket
2 Breather Hose
3 Bolt (Rear)
4 Nut . . . . . . . . . . . . . . 95-142 Nm
5 Cross Member
6 Bolt (Front)
7 Bushing
8 Spacer
FRONT AXLE
9 Bushing
10 Nut . . . . . . . . . . . . . . 95-142 Nm
11 Front Axle Assembly
12 Nut . . . . . . . . . . . . . ... 70-80 Nm
13 Bolt
14 Inner Axle Shaft (LH)
15 Inner Axle Shaft (RH)
Preceding Work : Removal of the front axle drive shaft
Removla of the steering gear box
FRONT DRIVE AXLE 3A-15
Removal & Installation Procedure
1. Remove the propeller shaft from the front axle input shaft.
Notice
Before removal, place the alignment marks.
Installation Notice
2. Remove the breather hose.
3. Remove the axle housing mounting nuts (1) from the cross
member.
Installation Notice
Tightening Torque
70 - 80 Nm
4. Remove the cross member mounting nuts (2) from the frame
and remove the cross member.
Installation Notice
Tightening Torque
95 - 142 Nm
5. Support the axle housing on a suitable jack, Remove the
axle housing mounting bracket nuts.
Installation Notice
Tightening Torque
62 - 93 Nm
Tightening Torque
95 - 142 Nm
6. Lowering the jack carefully, remove the axle housing
assembly.
7. Installation should follow the removal precedure in the
reverse order.
3A-16 FRONT DRIVE AXLE
UNIT REPAIR
AXLE HOUSING
Preceding Work : Removal of the axle housing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст