SsangYong Musso. Manual — part 435
FRONT DRIVE AXLE 3A-9
Removal & Installation Procedure
1. Remove the tire.
Installation Notice
Steel Wheel
Aluminum Wheel
Tightening Torque
80 - 120 Nm
110 - 130 Nm
2. Remove the autolocking hub vacuum hose.
3. With ABS
Remove the wheel speed sensor from the steering knuckle.
Installation Notice
4. Remove the mounting bolts and pull off the caliper assembly.
Installation Notice
Tightening Torque
6 - 8 Nm
Hose Bolt
Mounting Bolt
Tightening Torque
25 - 35 Nm
85 - 105 Nm
Notice
Be careful not to damage the brake hose.
3A-10 FRONT DRIVE AXLE
5.
With part time transfer case.
5-1. Remove the cover mounting bolts and pull off the cover.
Installation Notice
5-2. Remove the snap ring of the drive shaft and pull off the
hub body.
Notice
For assembly, adjust the clearance between the snap ring
and hub not to exceed 0.2 mm (Shim thickness : 0.1, 0.2,
0.3, 0.5, 1.0 mm).
Tightening Torque
50 - 60 Nm
6.
With full time transfer case
6-1. Detach the hub cap with screw driver and remove the
snap ring on drive shaft.
Installation Notice
Tightening Torque
2 - 4 Nm
5-3. Remove the screws and pull off the locking hub washer.
Installation Notice
Notice
For assembly, adjust the clearance between the snap ring
and hub not to exceed 0.2 mm (Shim thickness : 0.1, 0.2,
0.3, 0.5, 1.0 mm).
Tightening Torque
15 Nm
FRONT DRIVE AXLE 3A-11
8.
Remove the hub and disk assembly.
9.
Remove the disk brake dust shield.
Installation Notice
Tightening Torque
4 - 6 Nm
6-2. Unscrew the bolts and remove hub flange.
Installation Notice
Tightening Torque
70 - 90 Nm
Before installation, apply loctite on the mating surface.
7.
Remove the hub nut with special tool.
Tightening Torque
15 Nm
3A-12 FRONT DRIVE AXLE
10. Remove the cotter pin and slotted nut and then remove
the steering knuckle arm and tie-rod.
Installation Notice
Replace the cotter pin with new one.
Tightening Torque
35 - 45 Nm
11. Remove the cotter pin and nut from the steering knuckle
arm and upper arm ball joint connection.
Installation Notice
Tightening Torque
80 - 150 Nm
Replace the cotter pin with new one.
12. Remove the cotter pin and nut from the steering knuckle
arm and lower and lower arm boll joint connection.
13. Carefully remove the knuckle arm.
Installation Notice
Tightening Torque
120 - 180 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст