SsangYong Musso. Manual — part 398
1B3-154 OM600 ENGINE MECHANICAL
4. Position the no. 1 cylinder at the TDC of OT.
6. Pull out the bearing pins (9, 11) with sliding hammer and
remove the guide rail 10.
Sliding Hammer 116 589 20 33 00
Threaded Pin 116 589 02 34 00
Installation Procedure
1. Apply collar of both bearing pins with sealing compound.
2. Position the guide rail and insert the bearing pins.
3. Install the camshaft sprocket.
Tightening Torque
10 Nm
Notice
If the max. length ‘L’ of the 12-sided bolt exceeds 53.6mm,
replace it.
OM600 ENGINE MECHANICAL 1B3-155
In this position, the marking on the camshaft / camshaft
bearing cap (arrow) must also be aligned.
5. Install the guide pulley (12).
Tightening Torque
23 Nm
6. Attach the tensioning lever (7) to the spring (15) and install.
7. Replace the gasket and install the cylinder head cover.
Tightening Torque
10 Nm
1B3-156 OM600 ENGINE MECHANICAL
TIMING CASE COVER GUIDE RAIL
Preceding Work : Removal of cylinder head cover
1 Bearing Pin
2 Bearing Pin
3 Guide Rail
4 Oil Pump Chain
5 Crankshaft
6 Spring
7 Bushing
8 Tensioning Lever
OM600 ENGINE MECHANICAL 1B3-157
Removal Procedure
1. Pull out the tensioning lever (8) together with the spring (6)
and guide rail (3) far enough until the tensioning lever has
moved passed the oil pump chain (4) and is resting against
the crankshaft (5)
2. Pull the tensioning lever (8) off the bearing pin (2) and
carefully remove the spring (6). Remove the tensioning lever
(8) together with the spring (6) and bushing (7).
3. Remove the guide rail (3).
Installation Procedure
1. Install the guide rail (3). Attach the spring (6) to the guide
rail and to the tensioning lever (8).
Notice
Ensure that the spring is correctly located in the guide rail
(arrow).
2. Push the guide rail, spring, bushing and tensioning lever
together onto the bearing pin (1, 2).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст