SsangYong Musso. Manual — part 275
M161 ENGINE MECHANICAL 1B2-27
1 Upper Nut
2 Hydraulic Installer . . . . . 62~93 Nm
3 Lower Nut . . . . . . . . 28~47 Nm
Removal and Installation Procedure
1. Unscrew the upper nut(1) on engine mounting and remove
the engine.
Installation Notice
3. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
62 - 93 Nm
2. Unscrew the lower nut(3) and remove the hydraulic engine
mounting insulator.
Installation Notice
Tightening Torque
28 - 47 Nm
Notice
If the insulator is spotted with oil, replace the hydraulic
insulator assembly.
1B2-28 M161 ENGINE MECHANICAL
POLY V-BELT
Preceding Work : Removal of cooling fan
1 Poly V-belt (2,155 mm)
2 Belt Tensioning Pulley
Removal & Installation Procedure
1. Release the belt tension by turning the stud on the cap with
12 sided wrench or spanner counterclockwise.
2. Remove the poly v-belt.
Notice
Check the belt for damage and tensioning pulley bearing
point for wear and replace them if necessary.
3. Install the belt after prying the tensioning pulley.
3 Belt Tensioner
M161 ENGINE MECHANICAL 1B2-29
Poly V-belt Arrangement
1 Belt Tensioning Pulley
2 Crankshaft Belt Pulley
3 A/C Compressor Pulley
5 Alternator Pulley
7 Power Steering Pump Pulley
8 Water Pump Pulley
1B2-30 M161 ENGINE MECHANICAL
TENSIONING DEVICE
Preceding Work : Removal of tensioning device shock absorber
1 Bolt (M8 x 75, 2 pieces) +
Washer . . . . . . . . . . .. 22.5-27.5 Nm
2 Bolt (M8 x 25, 1 pieces) +
Washer . . . . . . . . . . .. 22.5-27.5 Nm
Removal & Installation Procedure
1. Turn the stud bolt to counterclockwise.
2. Insert the pin (111 589 01 15 00) into the hole in tensioning
arm.
3. Unscrew the bolts (1, 2) and remove the tensioning device.
Installation Notice
4. Installation should follow the removal procedure in the
reverse order.
3 Tensioning Device
4 Stud bolt
5 Tensioning Arm
Tightening Torque
22.5 - 27.5 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст