SsangYong Musso. Manual — part 4
MUSSO-SPORTS 1A-13
SUPPLEMENT
KAA5A020
KAA5A020
KAA5A020
VACUUM MODULATOR 1, 2
Removal and Installation Procedure
1. Disconnect vacuum hose and connector from vacuum
module.
2. After releasing fixing bolt from bracket of intake
manifold, and then remove vacuum modulator.
3. Installation should follow the removal procedures in
the reverse order.
KAA5A020
EGR VALVE AND LIFT SENSOR
Removal and Installation Procedure
1. Disconnect vacuum hose and connector from the
EGR valve.
2. After releasing the clamping bolt/nut of EGR Valve
pipe and then remove the clamp.
3. After releasing fixing bolt of EGR Valve of Intake
Manifold, remove the EGR Valve assembly.
4. Installation should follow the removal procedure in
the reverse order.
COOLANT TEMPERATURE SENSOR
Removal and Installation Procedure
1. Disconnect the coolant temperature sensor from the
coolant temperature sensor.
2. After releasing the coolant temperature sensor from
cylinder block and then remove the coolant tempera-
ture sensor.
3. Installation should follow the removal procedure in
the reverse order.
SOLENOID VALVE
Removal and Installation Procedure
1. Disconnect vacuum hose(3ea) and connector from
the solenoid valve.
2. Remove the solenoid valve from the fixing bracket of
injection pump.
3. Installation should follow the removal procedure in
the reverse order.
1A-14 MUSSO-SPORTS
SUPPLEMENT
KAA5A020
KAA5A020
KAA5A020
Removal and Installation of Rear Combi-Lamp
1. After pulling the tailgate, release fixing bolt of the
tail lamp assembly.
2. Carefully remove the tail lamp assembly.
3. Remove the wiring connector of tail lamp.
4. Installation should follow the removal procedure in
the reverse order.
MUSSO-SPORTS 1A-15
SUPPLEMENT
KAA5A020
KAA5A020
KAA5A020
Removal and Installation of Luggage Deck
Preceding work: Removal of tail lamp assembly
1. After removing the tail lamp assembly, release upper
two screw and one lower. Screw of the side bumper
cover.
KAA5A020
2. Carefully remove the cover of bumper side.
Note: Due to the opposite fixing section of the cover
screw of bumper side is the locking fastener, so it is
fragile part careful remove this one.
3. After releasing four fixing bolt of rear bumper, and
then remove the bumper.
4. Remove the wiring of tail lamp and the operation cable
of fuel filler.
1A-16 MUSSO-SPORTS
SUPPLEMENT
엔드크로스멤버
엔드크로스멤버
엔드크로스멤버
엔드크로스멤버
KAA5A020
KAA5A020
KAA5A020
5. Release the front fixing bolt mounting of luggage
deck.
KAA5A020
6. Release the rear fixing bolt mounting of luggage deck.
Note: In order for other materials not to enter into
fuel filler and breather.
7. Due to removal of luggage deck, check if damage
happen on the harness and other parts, and then
remove the luggage deck.
8. Install the reverse order of removal.
End Cross Member
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст