SsangYong Musso. Manual — part 32
9R-4 BODY FRONT END
Adjustment Procedure
1. Alignment between hood striker and latch hole.
!
Loosen the mounting bolt of hood latch slightly and adjust
hood in forward/rearward and left/right directions. Then
align the center between hood striker and latch hole.
Notice
Tighten the bolt fully after alignment.
Installation Notice
Tightening Toque
13 - 26 Nm
2. Adjusting the height of hood overslam bumper.
Unlock the hood and check the clearance between hood
and fender by adjusting the hood overslam bumper in left/
right directions.
Normal
20 - 22 Nm
3. Hood Hinge.
!
Loosen the hood lock bolts.
!
Adjust the lock in forward/rearward and left/right
directions, align with the hood striker and adjust the hood
height.
BODY FRONT END 9R-5
FENDER
Removal Procedure
1. Remove the screws.
2. Remove the mudguard and wheel guard.
3. Disconnect the front lamps connectors.
4. Remove the front lamps.
9R-6 BODY FRONT END
5. Remove the fender mounting bolts.
Notice
Be careful not to damage the paintwork.
Installation Procedure
1. Installation should follow the removal procedure in the
reverse order.
Notice
Apply a tape sealer to the fender and body panel to prevent
rust in fender mounting bolts area.
Tightening Torque
7 - 9 Nm
SECTION 9T
REMOTE KEYLESS ENTRY AND
ANTI-THEFT SYSTEM
Caution: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise
noted.
TABLE OF CONTENTS
Specifications . . . . . . . . . . . . . . . . . . . . . . . . 9T-1
REKES Specifications . . . . . . . . . . . . . . . . . . . 9T-1
Schematic and Routing Diagrams . . . . . . . . 9T-2
REKES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9T-2
Diagnosis . . . . . . . . . . . . . . . . . . . . . . . . . . . 9T-3
SPECIFICATIONS
REKES SPECIFICATIONS
Diagnosis Test . . . . . . . . . . . . . . . . . . . . . . . . 9T-3
Maintenance and Repair . . . . . . . . . . . . . . . 9T-5
On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . . 9T-5
REKES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9T-5
Transmitter
Description
DC 3V
-10
°
C - 60
°
C
Changeable Coin Type LITHIUM Battery
(CR2032)
Above 2 years (10 times/day)
Application
Rated Voltage
Rated Range of Operating Temperature
Model
Durability
Description
DC 12V
DC 8V - 16V
-30
°
C - +80
°
C
Above 5M
Ω
Maximum 3mA
Application
Rated Voltage
Rated Range of Operating Voltage
Rated Range of Operating Temperature
Insulating Resistance
Arm Current
Receiver
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст