SsangYong Musso. Manual — part 302
1D2-6 M161 ENGINE COOLING
4. After complete draining of the coolant, remove the hose
connector to drain plug and reinstall the drain plug.
Installation Notice
5. Tighten the radiator lower drain cock.
6. Remove the de-aeration hose clamp in the coolant pump
and remove the de-aeration hose.
7. Fill up the coolant through the coolant reservoir tank.
Notice
z
Match the anti-freeze and the water ratio to 50 : 50.
z
Supplement the coolant until the coolant overflows to
the deaeration hose.
Tightening Torque
30 Nm
8. Insert the de-aeration hose and completely tighten the
clamp.
9. Check the coolant level in the coolant reservoir tank.
10. Warm up(until thermostat is opened) the engine and
recheck the coolant level in the reservoir tank and fill up
the coolant if necessary.
M161 ENGINE COOLING 1D2-7
COOLING FAN AND VISCOUS CLUTCH
1 Bolt (M6 X 14, 3 piece) . . . . . . ... 9-11 Nm
2 Cooling Fan
3 Viscous Clutch
4 Union Nut (Left Threaded Screw) ... 40.5-49.5 Nm
1D2-8 M161 ENGINE COOLING
Tools Required
111 589 02 01 00 Open End Wrench
111 589 00 40 00 Open End Wrench
Removal & Installation Procedure
1. Install the holder (special tool : 111 589 00 40 00) to the bolt
at the pulley as shown in the right figure to hold the pulley.
2. Remove the viscous clutch using an open end wrench
(special tool : 111 589 02 01 00).
Installation Notice
Notice
The union nut is left threaded screw.
3. Remove the 3 bolts (1) from the viscous clutch and remove
the cooling fan and the viscous clutch.
Installation Notice
Tightening Torque
40.5 - 49.5 Nm
Tightening Torque
9 - 11 Nm
Notice
You may change the procedure (2) and (3) if necessary.
4. Installation should follow the removal procedure in the
reverse order.
M161 ENGINE COOLING 1D2-9
COOLANT PUMP
Preceding Work : Removal of viscous clutch
1 Bolt (M6 X 45, 1 piece) . . . . . . ... 9-11 Nm
2 Bolt (M6 X 95, 1 piece) . . . . . . ... 9-11 Nm
3 Bolt (M6 X 25, 4 piece) . . . . . . ... 9-11 Nm
4 Bolt (M8 X 85, 2 piece) . . . . ... 20.5-20.5 Nm
5 Coolant Pump Housing
6 Bolt (M6 X 16, 4 piece) . . . . . . ... 9-11 Nm
7 Coolant Pump Pulley
8 Coolant Inlet Hose
9 Heater Hose
10 Coolant Bypass Hose
11 Gasket
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст