SsangYong Musso. Manual — part 365
1B3-22 OM600 ENGINE MECHANICAL
With Air Conditioner
Removal & Installation Procedure
1. Remove the nut.
2. Push the tensioning lever in direction of arrow with a rod
(F12 ´ 180mm) and pull out the bolt to the rear.
3. Push back the tensioning lever (arrow direction) to release
the spring tension and remove the belt.
4. Install the poly V-belt beginning at the tensioning pulley (7).
7 Tensioning Pulley
8 Crankshaft
9 Alternator
10 Coolant Pump
11 Guide Pulley
12 Power Steering Pump
13 Aircon. Compressor
Lengthe of Belt
Length (L)
Without Air Conditioner
2,100 mm
2,040 mm
OM600 ENGINE MECHANICAL 1B3-23
TENSIONING DEVICE
Preceding Work : Removal of cooling fan
1 Bolt . . . . . . . . . . . . . . . 21Nm
2 Damper
3 Nut . . . . . . . . . . . . . . . . 21Nm
4 Tensioning Lever
5 Guide Rail Pin
6 Bolt
7 Poly V-Belt
8 Belt Pulley
9 Bolt . . . . . . . . . . . . . . . 10Nm
10 Tensioning Pulley
11 Socket Bolt . . . . . . . . . . . . 29Nm
12 Closing Cover
13 Washer
14 Tensioning Lever
15 Fit Bolt . . . . . . . . . . . . . . 100Nm
16 Closing Cover
17 Spring
18 Bolt . . . . . . . . . . . . . . . 20Nm
1B3-24 OM600 ENGINE MECHANICAL
Removal & Installation Procedure
1. Remove the nut.
Installation Notice
Tightening Torque
10 Nm
2. Push the tensioning lever in direction of arrow with a rod
( F12 ´ 180mm ) and push out the bolt to the rear.
3. Push back the tensioning lever to release the spring tension
and remove the belt.
4. Remove the bolt (9) and then remove the belt pulley (8).
5. Remove the bolt (1, 18) and take off the damper (2).
Notice
Pay attention to installation position of the damper.
OM600 ENGINE MECHANICAL 1B3-25
6. Pull off the tensioning lever (4) from guide rail pin.
7. Remove the spring (17).
Installation Notice
Insert spring (17) with color coding (blue/violet) facing up.
8. Pry off the closing cover (12) and remove the socket bolt
(11) and then remove the tensioning pulley (10).
Installation Notice
Tightening Torque
29 Nm
9. Pry off the closing cover (16) and remove the fit bolt (15).
10. Remove the tensioning lever (14) and washer (13).
11. Clean thread in the timing case cover and fit bolt.
Installation Notice
Apply Loctite on thread of fit bolt.
Tightening Torque
100 Nm
12. Installation should follow the removal procedure in the
reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст