SsangYong Musso. Manual — part 259
M162 ENGINE MECHANICAL 1B1-79
17. Rivet the link pin.
Check the condition and it again if necessary.
18. Install the chain tensioner.
Installation Notice
19. Check the camshaft timing position.
Tightening
Torque
Screw Plug
40 Nm
Tensioner Assembly
72 - 88 Nm
1B1-80 M162 ENGINE MECHANICAL
TENSIONING RAIL
Preceding Work : Removal of timing gear case cover
1 Tensioning Rail
2 Plastic Guide
3 Tensioning Rail Pin
4 Guide Rail
Removal & Installation Procedure
1. Put the assembly mark at the camshaft sprocket and the
timing chain with the paint (arrow).
2. Remove the exhaust camshaft sprocket.
3. Remove the tensioning rail (1) from the tensioning rail pin
(3).
Notice
z
Replace the plastic guide (2) if it is damaged.
z
For installation, exactly align the plastic guide (2) with
the tensioning rail (1).
4. Installation should follow the removal procedure in the
reverse order.
5. Check the camshaft timing position.
M162 ENGINE MECHANICAL 1B1-81
Tools Required
104 589 01 01 00 Spanner
Removal & Installation Procedure
1. Remove the chain tensioner (1).
2. Turn the exhaust camshaft to the camshaft rotating direction
using the wrench (4) and loosen the timing chain at upper
guide rail (2).
3. Pull out the upper guide rail pin from the guide rail (2).
4. Turn the exhaust camshaft to the opposite direction of
rotation using the wrench (4, special tool : 104 589 01 01
00).
5. Check for damages at the upper sliding rail and replace it if
necessary. Install the upper guide rail pin.
6. Install the chain tensioner.
Installation Notice
CYLINDER HEAD GUIDE RAIL
Preceding Work : Removal of cylinder head cover
1 Chain Tensioner
2 Upper Guide Rail
3 Upper Guide Rail Pin
4 Wrench (Special Tool)
Tightening Torque
Screw Plug
40 Nm
Tensioner Assembly
72 - 88 Nm
1B1-82 M162 ENGINE MECHANICAL
CRANKCASE GUIDE RAIL
Preceding Work : Removal of timing gear case cover
1 Guide Rail
2 Plastic Guide
3 Guide Rail Pin
4 Tensioning Rail
Removal & Installation Procedure
1. Put the assembly mark at the camshaft sprocket and the
timing chain with the paint (arrow).
2. Remove the exhaust camshaft sprocket.
3. Remove the guide rail (1) from the guide rail pin (3).
Notice
z
Replace the plastic guide (2) if damaged.
z
Connect the plastic guide (2) and the guide rail (1) by
aligning them accurately when installing.
4. Installation should follow the removal procedure in the
reverse order.
5. Check the camshaft timing position.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст