SsangYong Musso. Manual — part 246
M162 ENGINE MECHANICAL 1B1-27
TENSIONING DEVICE
Preceding Work : Removal of poly v-belt
1 Belt (L = 2245)
2 Bolt Combi(M8 x 14, 3 pieces) + Washer
. . . . . . . . . . . . . ... 22.5-27.5Nm
Removal & Installation Procedure
1. Remove the poly v-belt.
2. Remove the tensioning pulley by turning its mounting nut
counter clockwise as shown in figure.
Installation Notice
3 Water Pump Pulley
4 Nut
5 Tensioning Pulley
Tightening Torque
40.5 - 49.5 Nm
1B1-28 M162 ENGINE MECHANICAL
4. Remove the mounting bolts(M8 x 30, 3 pieces) at the
tensioning device, and remove the tensioning device (arrow).
Installation Notice
3. Remove the 3 bolts (2) and remove the water pump pulley
(arrow).
Installation Notice
5. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
22.5 - 27.5 Nm
Tightening Torque
26 - 32 Nm
M162 ENGINE MECHANICAL 1B1-29
3. Pointed rib.
4. Belt cord visible in the base of rib.
POLY V - BELT INSPECTION
z
Make marks on the belt with chalk.
z
Rotate the engine and check the belt for damage.
Notice
If one of the following types of damages is found, replace
the belt.
1. Rubber lumps in the base of rib.
2. Dirt or grit ingrained.
5. Cord torn out at the side.
6. Outer cords frayed.
1B1-30 M162 ENGINE MECHANICAL
7. Rib detached from the base of belt.
8. Splits across the rib.
9. Sections of rib torn out.
10. Splits across several ribs.
11. Splits across the back of the belt.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст