SsangYong Korando III (2010 year). Manual — part 144
03-8
Seat belt reminder (SBR)
Previous
Current
If the driver seat belt is not fastened with the
ignition switch ON, engine running and vehicle
speed above 10 km/h, the seat belt reminder is
activated.
In addition, even though the vehicle speed reduces
to below 10 km/h after the reminder is activated at
speed of 10 km/h or higher, it will remain activated.
If the driver seat belt is not fastened with the
ignition switch ON, engine running and vehicle
speed above 25 km/h, the seat belt reminder is
activated.
In addition, if the seat belt reminder is activated at
the speed of 25 km/h or higher and the speed
reduces to below 25 km/h within 5 minutes, the
interior buzzer sound stops. The buzzer sounds for
5 minutes again when the speed is 25 km/h or
higher.
03-9
8710-01
1. OVERVIEW & FUNCTIONS
BCM (Body Control Module) controls the electric equipment on car body and outputs the control and
warning signals as below.
List
Function
List
Function
1
Wiper control
14
Tailgate open control
2
Ignition key reminder warning
15
Theft deterrent
3
Tail lamp control
16
Time lag power window control
4
Door ajar warning
17
System power sleep mode
5
Seat belt control
18
Flasher function
6
Sunroof warning
19
DRL (daytime running lamp) control
7
Room lamp control
20
Fog lamp control
8
Key hole illumination control
21
Auto light control (LIN)
9
Defogger control
22
Immobilizer function
10
Keyless entry function
23
Folding/unfolding function
11
Door lock/unlock control
24
Approach (puddle) lamp control
12
Panic alarm
25
SKM warning buzzer control
13
Headlamp control (escort)
26
Diagnosis function
<Table 1>
03-10
1) Wiper Control
(1) Wiper mist & front washer coupled wiper
Wiper mist
▶
When the multi-function switch is rotated for more than 0.1 second to activate the mist mode with
IGN1 ON, the wiper relay is activated after 0.1 second. It will be deactivated when the wiper motor
is in the parking position.
While the wiper operates at high speed when the mist switch signal is received, it operates at low
speed if the switch is returned to its starting position.
1.
2.
Front washer coupled wiper
▶
When holding the front washer switch at ON position for more than 0.6 seconds with IGN ON, the
wiper relay is activated 0.5 seconds after. The wiper stops after three more wipes since that the
washer switch is turned to "OFF" position.
1.
03-11
8710-01
Rear washer motor control
▶
When turning ON the rear washer switch with the key inserted and IGN ON, the washer fluid is
sprayed the side fascia panel.
If the front washer or automatic washer switch signal is received during the rear washer switch
operation, the washer motor stops and the front washer or automatic washer motor begins to operate.
1.
2.
When holding the front washer switch at ON position for 0.1 to 0.59 seconds during the wiper
operation by the intermittent/automatic wiper switch, the wiper will operate only once. When holding
the washer switch for more than 0.6 seconds, the wiper relay is activated 0.5 seconds after. The
wiper stops after three more wipes since that the washer switch is turned to "OFF" position.
3.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст