SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 372
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
FRONT SUSP & AXLE
STAVIC - 2004.09
36
4E
1. Unscrew the lock nut (1) and brake disk mounting bolts
(2: 5 mm - 2EA) and then, remove the disk from knuckle
assembly.
2. Unscrew the brake dust shield mounting bolts (3EA).
[Notice]
Keep the tightening torque and if the position of pin hole is
improper, rotate the nut to the tightening direction.
3. Remove the knuckle mounting bolts in the following order
A. Tie rod end nut (19mm - 1EA)
: Remove the pin first (A)
Tightening torque
8 ~ 12 Nm
Tightening torque
8 ~ 12 Nm
Tightening torque
35 ~ 45 Nm
B. Lower arm bolt nut (19mm - 1EA)
: Release the bolt first. Remove after upper arm bolt
(C) is removed.
C. Upper arm bolt/nut (19mm -1EA)
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
FRONT SUSP & AXLE
STAVIC - 2004.09
37
4E
4. Remove the front wheel nuckle from the drive shaft.
5. Install in the reverse order of removal.
(Replace the brake disk lock nut with new one for every disassembly and do the cocking job for the nut)
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
FRONT SUSP & AXLE
STAVIC - 2004.09
38
4E
Broken stabilizer bar
Faulty shock absorber
Loosening mountings
Damaged or worn wheel bearing
Damaged shock absorber
Damaged tire
Over inflated tire
Faulty shock absorber
Loosened wheel bolt
Bent or broken coil spring
Damaged tire
Worn bushing
Deformed arm assembly
Worn bushing
Bent or broken coil spring
Incorrect front wheel alignment
Excessive resistance of lower arm ball joint
Insufficient tire pressure
Faulty power steering
Incorrect front wheel alignment
Worn or loosened lower arm bushing
Worn or broken coil spring
Vehicle rolling
Abnormal noises
Poor riding
Vehicle pulls to right or left
Hard steering
Steering instability
Vehicle bottoming
Cause
Action
Symptom
TROUBLE DIAGNOSIS
Replace
Replace
Re-tighten
Replace
Replace
Replace
Pressure adjust
Replace
Tighten as specified torque
Replace
Replace
Replace
Replace
Replace
Replace
Repair
Replace
Adjust
Repair or replace
Repair
Re-tighten or replace
Replace
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
2
REAR SUSP & AXLE
STAVIC - 2004.09
4F
REAR AXLE CARRIER (MODULE)
1. SYSTEM OVERVIEW
Shock absorber
Coil spring
Axle shaft
Stabilizer
Thrust link
Track rod
Tension link
Wheel carrier
Camber link
Axle mounting
Front View
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст