SsangYong Stavic / SsangYong Rodius (2005 year). Manual — part 272
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
10
2I
Replacement of Headlamp Bulb
1. Remove the headlamp dust cover.
High beam cover
Low beam cover
Push
2. Disconnect the headlamp bulb connector.
3. Push up the bulb clamp to remove it.
Remove
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
11
2I
4. Remove the bulb and install new bulb with same
specifications.
Replacement of Tail Lamp/Turn
Signal Lamp
1. Disconnect the tail lamp/turn signal lamp connector from
the headlamp assembly.
2. Remove the tail lamp/turn signal lamp bulbs from the headlamp assembly and install new bulb with same
specifications.
Tail lamp bulb assembly
Turn signal lamp bulb assembly
Headlamp (low beam) bulb assembly
Headlamp (high beam) bulb assembly
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
12
2I
2) Fog Lamp Assembly
Removal and Installation of Fog Lamp Assembly
Preceding work: Disconnection of negative battery cable
1. Disconnect the fog lamp connector.
2. Remove the mounting screws (when removing the
assembly).
3. Remove the fog lamp bulb (when only removing
the bulb).
4. Remove the fog lamp assembly.
Lamp
Bulb
Bulb connector
Lamp cover
Mounting screws
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
13
2I
3) Side Turn Signal Lamp Assembly
Removal and Installation of Side Turn Signal Lamp
Preceding work: Disconnection of negative battery cable
2. Disconnect the connector and remove the lamp.
Bulb connector
Bulb assembly
Lamp assembly
Bulb cover rubber ring:
If the cover rubber ring is defective,
replace it with new one.
1. Push the turn signal lamp forward and pull in the rear
side of the lamp to separate.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст