SsangYong Rodius (2013 year). Manual — part 159
08-8
Problem
Cause
Action
Burning smell
around tire
Too frequent braking in high driving speed
Reduce the use of
foot brake/use
engine brake
properly
Use only foot brake during downhill driving
Driving with foot on brake pedal
Get off the foot from
pedal
Foreign materials such as dirt or sand in brake system
Replace: caliper,
wheel cylinder,
master cylinder,
return spring
Broken return spring in shoe assembly
Replace
Incorrectly adjusted parking brake cable
Adjust
Incorrect wheel or wheel cover
(generating the heat)
Replace
08-9
4850-03
Measure the disc thickness at over four
points.
If any of measured points is below the wear
limit, replace the brake disc with new one.
1.
2.
Clean the dissembled components and visually check the followings:
- Wear, rust and damage on the cylinder and piston
- Damage, crack and wear on cylinder body and guide pin
- Uneven wear and oil contamination on pad
- Damage and tear on boot
- Scratch and bending on disc plate
▶Pad Thickness
Remove the front tire.
Measure the pad thickness and replace it if it
is below the wear limit.
1.
2.
New pad
Wear limit
28.0 mm
25.4 mm
▶Brake Disc Thickness
New pad
Wear limit
10.5 mm
2 mm
5. INSPECTION
1) Front Brake System
Replace the brake pads at both sides as a
set.
08-10
Install the dial gauge on the side of brake disc
and measure the run-out while rotating the
brake disc.
If the measured value exceeds the limit,
replace the brake disc with new one.
Otherwise, it may cause the pedal vibration
and shimmy when braking.
1.
2.
Limit
0.03 mm
(before installation)
0.07 mm (after installation)
Disc Run-Out
▶
08-11
4850-03
Clean the dissembled components and visually check the followings:
- Wear, rust and damage on the cylinder and piston
- Damage, crack and wear on cylinder body and guide pin
- Uneven wear and oil contamination on pad
- Damage and tear on boot
- Scratch and bending on disc plate
Remove the rear tire.
Measure the pad thickness and replace it if it
is below the wear limit.
1.
2.
New pad
Wear limit
20.0 mm
18.4 mm
Replace the brake pads at both sides as a
set.
Measure the disc thickness at over ten
points.
If any of measured points is below the wear
limit, replace the brake disc with new one.
1.
2.
New pad
Wear limit
10 mm
2 mm
2) Rear Brake System
Pad Thickness
▶
Brake Disc Thickness
▶
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст