SsangYong Rodius (2013 year). Manual — part 160
08-12
Let the engine run for 1 to 2 minutes and
stop it. If the brake pedal stroke is shortened
as pumping the brake pedal, the system is
normal. If not, the system is defective.
1.
Depress the brake pedal several times with
engine off. If the brake goes down when
starting engine with pedal depressed, the
system is normal. If not, the system is
defective.
2.
If the above three checks are OK, the system is
normal. If any condition is not met, check the
valve, vacuum hose and brake booster.
3) Brake Booster
OK
NG
Engine stopped
Engine running
Depress the brake pedal when the engine is
running. If the pedal height is not changed
for 30 seconds after stopping the engine, the
system is normal. If not, the system is
defective.
3.
08-13
4850-03
Stop Lamp Switch
Connector
Internal circuit
4) Stop Lamp Switch
Connect the multimeter to stop lamp switch
connector (N.O.) and check if the continuity
exists when pushing in the plunger. If the
continuity doesn't exist, the stop lamp switch
is normal.
Connect the multimeter to stop lamp switch
connector (N.C.) and check if the continuity
exists when pushing in the plunger. If the
continuity doesn't exist, the stop lamp switch
is normal.
1.
2.
Type
Plunger
Pushed
Not pushed
N.C Continuity
Not continuity
N.O
Not continuity
Continuity
5) Pedal Free Play
Check the pedal free play with below
procedures:
-
Stop the engine.
Depress the brake pedal several times to
discharge the vacuum pressure of the
brake booster.
Depress the brake pedal until you feel the
resistance, and measure the movement
(A).
1.
2.
3.
Specified value(A)
3 ~ 10 mm
If the free play is below the specified value, check if
the clearance between the outer case of the stop
lamp and the brake pedal is within the specified
range. If the clearance is out of the specified range,
the clearance between the clevis pin and the brake
pedal arm is too large. Check the components and
repair if needed.
08-14
Parking Brake Adjustment
▶
Adjust the brake adjuster using a flat-bladed screwdriver so that the parking brake shoe is tight on the
inner face of the brake disk when installing it, then unscrew the adjuster by 4 ~ 5 notch. (Clearance
between the inner face of brake disk and brake shoe should be about 0.2 mm)
1.
Turn in direction of (A) to decrease the clearance
Turn in direction of (B) to increase the clearance
-
-
1
Adjust the parking brake shoe, depress the
parking brake pedal 5 times and release it.
2.
Adjust the equalizer assembly bolt under
the vehicle so that the equalizer assembly
stops at the first notch when the parking
brake pedal is depressed with a force of 19
to 22 kgf.
3.
Turn in the direction of (A) to tension the
parking brake cable
Turn in the direction of (B) to loosen the
parking brake cable
-
-
08-15
4850-03
1. COMPONENTS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст