SsangYong Rexton. Manual — part 649
RESTRAINTS 8B-19
SSANGYONG Y200
BELT PRETENSIONER
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Remove the upper belt bolt and disconnect the
panel.
3. Disconnect the airbag wiring connector.
4. Remove the mounting bolt of the belt pretensioner
and remove the belt assembly.
4. Remove the SDM mounting bolt and remove the
SDM assembly.
5. Installation should follow the removal procedure
in the reverse order.
YAD8B210
YAD8B220
YAD8B230
5. Tighten the pretensioner mounting bolt as the
specified torque.
Installation should follow the removal procedure
in the reverse order.
SENSING AND DIAGNOSTIC
MODULE (SDM)
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Remove the I/P center panel and the console
panel.
3. Remove the SDM connector.
YAD8B240
SSANGYONG Y200
8B-20 RESTRAINTS
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS TABLE
Scan Tool
Wheel Wrench
YAD8B250
YAD8B260
SECTION 9A
GENERAL BODY
TABLE OF CONTENTS
Specification . . . . . . . . . . . . . . 9A-2
Dignosis and Action Taken . . . . . . . . ... 9A-3
Diagnosis for Leaking Water . . . . . . . . 9A-3
Check and Repair . . . . . . . . . . . . . 9A-4
Check . . . . . . . . . . . . . . . . . 9A-4
Repair . . . . . . . . . . . . . . . . . 9A-7
Special Tool and Equipment . . . . . . . . 9A-9
Special Tools Table . . . . . . . . . . . .. 9A-9
SSANGYONG Y200
9A-2 GENERAL BODY
SPECIFICATION
Rear Hinge and Type of Front Opening, Gas Lifter
Front Hinge and Frame Door
Wire and Drum
Pin and Fork
Front Hinge and Frame Door
Wire and Drum
Pin and Fork
Internal Hinge, Gas Lifter
5 mm
4.0 mm
4.0 mm
4.0 mm
4.0 mm
5.0 mm
Spray Nozzle of #1/2 GG-25 or Nozzle with Sloping
Angle 60° Equivalent
Keep Distance 1,600 mm from Ground
14L Per Mir
155kPa(22.5 psi): Checking Pressure from nozzle
Keep Injecting Water, 30° of Lower Direction and 45°
of Backwards, Approximately at the corner of Wind-
shield
Keep Injecting Water, 30° of Lower Direction and 45°
of Backwards, Approximately at the corner Line of
Rear Door.
Keep Injecting Water, 30° of Lower Direction and 45°
of Forwards, Approximately at Distance of 60mm to
the Corner of Rear Door
Type
Structure
Type of Regulator
Lock System
Structure
Type of Regulator
Lock System
Type
Wind Shield
Front Door Glass
Rear Door Glass
Rear Fix Glass
Glass of Tail Gate
Type of Nozzle
Height of Nozzle
Quantity of Injecting
Pressure
Position of a Piller Test Stand and
Wing Shield
Position of “B” Piller Test Stand
Position of Rear Decklid Test and Tail
Gate Glass
Application
Specification
Hood
Front Door
Rear Door
Tail Gate
Thickness of
Glass
Specification
of Test Water
Leaking
Fixing Type
Opening Type
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст