SsangYong Rexton. Manual — part 350
M161 ENGINE MECHANICAL 1B2-83
SSANGYONG Y200
YAD1B980
YAD1B990
YAD1B0A0
Inspection
1. Measure the basic bore of the connecting rod
bearing.
Notice: If the basic bore exceeds the value of
51.614 mm, replace the bearing or check the
connecting rod.
3. C h e c k t h e a s s e m b l y m a r k ( i n d i c a t i o n / / o r
number:arrow) of the connecting rods and the
bearing cap when installing.
Notice:
•
Make sure it doesn’t exceed over 4g with other
connecting rods when replacing the connecting
rods.
•
Check if the connecting rod and the bearing
cap are accurately seated on the groove when
replacing the bearing.
2. Check connecting rod bolts.
51.7 - 52 mm
52.9 mm
1st step : 40 N•m
(30 lb-ft)
2nd step : 90°
Notice: If the length exceeds max. length, replace
it.
Length When New (L)
Max. Length (L)
Tightening Torque
SSANGYONG Y200
1B2-84 M161 ENGINE MECHANICAL
PISTON RING
Preceding Work:
Removal of piston
1 Piston Compression Ring (Top Ring)
2 Piston Compression Ring (2nd Ring)
3 Piston Oil Ring
YAD1B2T0
4 -
5 Spacer
6 SideRail
M161 ENGINE MECHANICAL 1B2-85
SSANGYONG Y200
YAD1B2U0
YAD1B2V0
Replacement Procedure
1. Measure the piston ring’s gap.
Notice: If out of specification, replace the piston
ring.
3. For installation, position the piston ring to be the
‘TOP’ mark on the piston ring upward and arrange
the piston ring ends to be 120 ° part.
4. Adjust the hook spring joint in the oil ring 180 °
way from the ring end.
2. Remove the piston ring with a pliers.
End Gap of the
Piston Ring
Gap Between
the Piston and the
Piston Ring
Groove 1 0.20 - 0.40 mm
Groove 2 0.20 - 0.40 mm
Groove 3 0.20 - 0.45 mm
Groove 1 0.028 - 0.060 mm
Groove 2 0.010 - 0.045 mm
Groove 3 0.010 - 0.045 mm
SSANGYONG Y200
1B2-86 M161 ENGINE MECHANICAL
OIL PAN
1 Bolt
2 Bolt
3 Bolt
4 Bolt
Removal & Installation Procedure
1. R e m o v e t h e d r a i n p l u g a n d d r a i n t h e o i l
completely.
2. Unscrew the bolts and remove the oil pan and
gasket.
Notice: Arrange the bolts according to each size.
3. Clean the inside of oil pan and sealing surface,
then apply the sealant.
4. Replace the gasket with new one.
5. Install the oil pan with gasket, and tighten each
bolt in specified torque.
6. Check for oil leaks while running the engine.
YAD1B7P0
5 Bolt
6 OilPan
7 Gasket
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст