SsangYong Rexton. Manual — part 465
FRONT SUSPENSION 2C-9
SSANGYONG Y200
REPAIR INSTRUCTIONS
ON-VEHICLE SERVICE
YAD2C080
SSANGYONG Y200
2C-10 FRONT SUSPENSION
1 Nut
2 Nut
3 Washer
4 Rubber
5 Bushing
6 Upper Spring Sheet
7 Rubber
8 Spring Sheet Rubber
9 Boot
10 Boot
11 Spring
12 Shock Absorber
13 Lower Spring Sheet
14 Yoke
15 Nut
16 Bolt
17 Bolt
18 Bolt
19 Bushing
20 Nut
21 Upper Arm
22 Nut
23 Bushing
24 Washer
25 Bolt
26 Lower Arm
27 Bushing
28 Bushing
FRONT SUSPENSION 2C-11
SSANGYONG Y200
STABILIZER
Removal Procedure
1. Remove the skid plate at front bottom side.
YAD2C090
YAD2C100
YAD2C110
2. Remove the upper mounting nut and the lower
mounting nut from the front stabilizer bar link.
Remove the front stabilizer bar link.
3. Remove the mounting cap bolt from the front
stabilizer bar and remove the front stabilizer bar.
YAD2C120
Installation Procedure
1. Install the front stabilizer bar to the frame and
tighten manually the stabilizer bar mounting cap
bolt. It allows the bar link to install to it’s original
position.
Installation Notice
Tightening Torque
60 - 80 N•m
(44 - 59 lb-ft)
SSANGYONG Y200
2C-12 FRONT SUSPENSION
3. Install the front stabilizer bar and the skid plate.
Installation Notice
YAD2C140
YAD2C150
SHOCK ABSORBER ASSEMBLY
Removal Procedure
1. Remove three upper nuts from the shock absorber
assembly.
2. Install the bra link between the stabilizer bar and
the lower arm and tighten the mounting nut as the
specified torque.
Installation Notice
YAD2C130
Tightening
Torque
(1) 110 - 120 N•m
(2) 110 - 130 N•m
YAD2C160
2. Remove the yoke mounting pin nut at the lower
arm and the yoke mounting pin.
Tightening Torque
35 N•m (26 lb-ft)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст