SsangYong Rexton. Manual — part 102
DI10-13
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10031
Y220_10032
Y220_10033
Y220_10034
Injector Coding (C2I)
Preceding Work: Perform the “Entering Diagnosis Proce-
dures”
Notice
If the injector/ECU has been replaced or the injector system
defective is suspected, go to C2I Coding item and check
the injector and coded injector C2I value.
1. Select “6] INJECTOR (C2I) CORRECTIONS” and press
“
” in “FUNCTION SELECTION” screen.
2. The “INJECTOR (C2I) CORRECTIONS” screen that shows
current C2I coding values of #1 to #5 injector is displayed.
3. If you replaced the ECU, enter the C2I value of the relevant
injector.
Note
•
The C2I value of replacing injector is recorded in
the label.
•
C2I coding number: 16 digits (ex, B1 B9 D4 1B 43
C6 0E 4F)
DI10-14
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10035
Y220_10036
3-1. If you enter the invalid C2I value of the relevant injector,
the message as shown in figure appears with alarm sound.
Note
If you want to go back to previous screen, press
“
” key. You can see the previous C2I value.
3-2. If you enter the valid C2I value of the relevant injector, the
message as shown in figure appears with alarm sound.
DI10-15
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10037
Y220_10038
Y220_10040
Leak Detection
Preceding Work: Perform the “Entering Diagnosis Proce-
dures”
Note
This item is for checking the high fuel pressure after the
IMV supply line of HP pump in DI engine fuel system. If
you still suspect that the fuel pressure system is defective
even after no trouble is detected, perform the fuel pressure
test again by using a fuel pressure tool kit.
1. Select “7] LEAK DETECTION” and press “
” in
“FUNCTION SELECTION” screen.
2. The “LEAK DETECTION” screen that shows the checking
conditions as shown in figure is displayed.
DI10-16
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10041
Y220_10042
Y220_10043
Y220_10044
Variant Coding
Preceding Work: Perform the “Entering Diagnosis Proce-
dures”
1. Select “8] VARIANT CODING” and press “
” in
“FUNCTION SELECTION” screen.
2. When the “VARIANT CODING” screen is displayed,
select “1] READ VARIANT VALUE” and press “
”.
3. The “VARIANT CODING” screen that shows currently
equipped devices is displayed.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст