SsangYong Rexton. Manual — part 338
M161 ENGINE MECHANICAL 1B2-35
SSANGYONG Y200
BELT PULLEY AND VIBRATION DAMPER
Preceding Work:
Removal of cooling fan and viscous clutch
Removal of fan shroud
Removal of drive belt
1 Vibration Damper Center
. . . ... 1st step 200+20 N•m (148 + 15 lb-ft)
2nd step 90 ° + 10 ° rotation added
YAD1B6U0
2 Vibration Damper Disk
5 Vibration Damper Assembly
6 Key
SSANGYONG Y200
1B2-36 M161 ENGINE MECHANICAL
Components
1 Center Bolt (M18 x 50)
2 Center Bolt Washer
3 Vibration Damper and Pulley Assembly
4 Key
5 Crankshaft Front Seal
6 Timing Gear Case Cover
YAD1B660
7 Crankshaft Sprocket (Camshaft Driven)
8 Crankshaft Sprocket (Oil Pump Driven)
9 Crankshaft
10 Oil Pan
11 Oil Pan Gasket
12 Oil Pan Mounting Bolt (M6 x 22)
Service Data Standard
Permissble Deviation of The Vibration Damper
Radial Runout
Axial Ruout
0.6 mm
0.6 mm
M161 ENGINE MECHANICAL 1B2-37
SSANGYONG Y200
YAD1B6V0
YAD1B680
YAD1B6W0
Tools Required
602 589 00 40 00
Engine Lock
Removal & Installation Procedure
1. Adjust the piston of number 1 cylinder to the TDC.
4. Remove the vibration damper assembly using the
puller.
5. Installation should follow the removal procedure
in the reverse order.
Notice: If possible, don’t separate the vibration
damper and the pulley.
2. Remove the start motor and install the engine lock
602 589 00 40 00 to the flywheel ring gear.
3. Remove the vibration damper center bolt.
Installation Notice
Tightening Torque
1st step: 200 + 20 N•m
(148 + 15 lb-ft)
2nd step: 90° + 10°
SSANGYONG Y200
1B2-38 M161 ENGINE MECHANICAL
CRANKSHAFT FRONT RADIAL SEAL
Preceding Work:
Removal of belt pulley and vibration damper
1 Center Bolt (M18 x 50)
. . . 1st step 200 + 20 45 N•m (148 +15 lb-ft)
2nd step 90 ° + 10 °
2 Center Bolt Washer
YAD1B6X0
3 Crankshaft Front Seal Installer
4 Crankshaft Front Seal
5 Key
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст