SsangYong Rexton. Manual — part 453
SSANGYONG Y200
1F3-32 DIESEL ENGINE CONTROLS
Position Sensor, RIV Method
YAD1FBG0
Service Data
4 Seal . . . . . . . . . . . . . . Replace
5 Screw Plug . . . . . . . ... 30 N•m (22 lb-ft)
1 Position Sensor
2 Battery
3 Fuel Injection Pump
Start of Delivery (RIV)
ATDC 14° - 16°
DIESEL ENGINE CONTROLS 1F3-33
SSANGYONG Y200
10
20
30
40
0 T
YAD1FBH0
YAD1FBJ0
YAD1BC10
Tools Required
617 589 08 21 00
Position Sensor
Test Procedure
1. Remove the screw plug (5) and seal (4) and collect
oil in a suitable vessel.
Installation Notice
4. Rotate the crankshaft by hand (in direction of
engine rotation) until the lamp ‘B’ lights up.
Rotate the crankshaft carefully further until both
lamps ‘A and B’ come on. In this position, check
the Rl value on the crankshaft vibration damper.
2. Install the position sensor 617 589 08 21 00 (1)
into the governor housing of the injection pump to
be the guide pin of the position sensor facing up.
3. Connect the battery terminal of position sensor
617 589 08 21 00 (1) to positive terminal (+) of
battery.
Notice: If only lamp ‘A’ lights up, repeat the test
and if out of specification, adjust start of delivery.
Tightening Torque
30 N•m (22 lb-ft)
Specification
ATDC 14° - 16°
SSANGYONG Y200
1F3-34 DIESEL ENGINE CONTROLS
Digital Tester, RIV Method
(Connection Diagram for Testers Without Adapter)
1 Fuel Injection Pump
2 Rl Sensor
3 Digital Tester
4 TDC Pulse Generator
5 Battery
YAD1FBF0
DIESEL ENGINE CONTROLS 1F3-35
SSANGYONG Y200
(Connection Diagram for Testers With Adapter)
YAD1FBK0
1 Fuel Injection Pump
2 Rl Sensor
3 Digital Tester
4 TDC Pulse Sender Unit
5 Battery
6 Rl Pulse Generator
Service Data
ATDC 14° - 16°
720 - 820 rpm
Start of Delivery (RIV)
Idle Speed
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст