SsangYong Rexton. Manual — part 483
FRONT AXLE 3A-27
SSANGYONG Y200
YAD3A700
YAD3A690
Inspection
1. Check the shaft spline for the wear and damage.
2. Check the leakage by the boot crack, tears.
3. Check the bending of shaft.
Notice: if the defect happens in one shaft, because
the other is damaged, exchange the both.
Assembly
1. Assembly should follow the dismantlement in the
reverse order.
2. Apply the specified grease to the joint housing.
Notice: If not use the specified grease, the joint
and boot may be damaged.
Notice: For assembly, replace the boot clamp with
the new one.
3. Check the followings after completing the
assembly.
•
Check whether the joint move to up/down, left/
right, forward freely.
•
Check whether the grease leak in the clamp part
after checking the operation.
Injection quantity
90 - 100 g
SSANGYONG Y200
3A-28 FRONT AXLE
WHEEL JOINT ASSEMBLY
Disassembly
1. Remove the drive axle.
2. Detach the joint boot clamp.
1 Detach the boot clamp (large)
2 Detach the boot clamp (Small)
•
After unfolding the clamp holding part by using
the driver/hammer, detach the clamp.
YAD3A710
YAD3A720
YAD3A740
YAD3A730
3. Get rid of the grease in the joint assembly.
4. Remove the joint assembly.
1 Spread out the circlip.
2 Pull out the joint assembly to the wheel side
with the circlip spread out.
5. Remove the drive axle shaft.
Assembly
1. A s s e m b l y s h o u l d f o l l o w t h e d i s a s s e m b l y
procedure in the reverse order.
2. Install the joint assembly.
•
Put the joint assembly in drive axle shaft to
spread out the circlip opening slightly.
1 Inser t (-) driver into the circlip opening to spread
out the circlip.
2 Put the joint assembly in circlip home with the
circlip spread out.
FRONT AXLE 3A-29
SSANGYONG Y200
3. Apply the specified grease to the joint housing.
Notice: If not use the specified grease, the joint
and boot may be damaged.
Notice: For assembly, replace the boot clamp with
the new one.
YAD3A750
YAD3A760
Injection quantity
80 - 90 g
4. Check the followings after completing the
assembly.
•
Check whether the joint move to up/down, left/
right, forward freely.
•
Check whether the grease leak in the clamp part
after checking the operation.
Notice: Because the wheel joint cannot be repaired
in single par t, if there is defect, replace it whit the
new assembly.
SSANGYONG Y200
3A-30 FRONT AXLE
SPECIAL TOOLS AND EQUIPMENT
SPECIAL TOOLS TABLE
661 589 13 33 00
Ball Joint Remover
Part Time Snap Ring
Remover / Installer
Snap Ring Plier
YAD3A770
YAD3A780
YAD3A790
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст