SsangYong Rexton. Manual — part 367
SSANGYONG Y200
1B3-44 DIESEL ENGINE MECHANICAL
YAD1BBU0
YAD1BCV0
YAD1BBV0
YAD1BCW0
26. Connect the fuel hose.
27. Install the cable channel and connect the cables
to glow plugs.
28. Replace the gasket and install the cylinder head
cover.
Installation Notice
30. C o n n e c t t h e w i r e s t o t h e e n g i n e c o o l a n t
temperature sensor and the glow plug sensor.
31. Replace the intake manifold gasket.
32. Install the intake manifold.
Installation Notice
29. Install the blow-by hose.
Tightening Torque
10 N•m (89 lb-in)
Tightening Torque
25 N•m (18 lb-ft)
DIESEL ENGINE MECHANICAL 1B3-45
SSANGYONG Y200
35. Install the fuel pipe and the accelerator control
linkage.
36. Connect the fuel lines to the injection nozzles and
to the injection pump.
Installation Notice
Tightening Torque
18 N•m (13 lb-ft)
YAD1BCY0
YAD1BBN0
YAD1BCZ0
37. Install the poly V-belt.
Notice: Be careful not to contaminate the belt.
33. Replace the O-ring of heater feed pipe and install
it to the cylinder head.
Notice: For installation, clean the hole.
34. Install the bracket of heater feed pipe to the oil
filter.
YAD1BCX0
SSANGYONG Y200
1B3-46 DIESEL ENGINE MECHANICAL
YAD1BB30
YAD1BBG0
YAD1BBF0
38. By inserting a rod into the tensioning lever upper
hole and pulling the rod, install the bolt and then
tighten the nut.
Installation Notice
39. Install the oil dipstick tube bracket.
Installation Notice
40. Hold the cooling fan with the counter holder 603
589 00 40 00 and tighten the bolt.
Tightening Torque
21 N•m (15 lb-ft)
Tightening Torque
10 N•m (89 lb-in)
DIESEL ENGINE MECHANICAL 1B3-47
SSANGYONG Y200
YAD1BD00
YAD1BD10
YAD1BD20
YAD1BD30
2. Install the sliding hammer 667 589 03 63 00 (5)
into the prechamber.
3. Remove the perchamber (2).
Notice: After removing the prechamber, cover over
the bores with clean rag.
4. Inspect the prechamber.
Notice: If the prechamber seats in the cylinder
head are leaking or if the prechambers are
replaced, the sealing surfaces in the cylinder head
must be remachined.
PRECHAMBER
Preceding work: Removal of glow plug
Removal of fuel injection nozzle
Tools Required
603 589 00 09 00
Serration Wrench
667 589 03 63 00
Sliding Hammer
Removal Procedure
1. Using the serration wrench 603 589 00 09 00 (4),
remove the threaded ring (1).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст