Isuzu Trooper (2000 year). Manual — part 394
7A–96
AUTOMATIC TRANSMISSION (4L30–E)
Extension Housing Assembly
Extension Housing Assembly and Associated Parts
260RY00006
Legend
(1) Propeller Shaft
(2) Mass
(3) Extension Housing Assembly
7A–97
AUTOMATIC TRANSMISSION (4L30–E)
Removal
1. Disconnect battery ground cable.
2. Raise and support vehicle with suitable stands.
3. Disconnect harness connectors and fuel pipe fix bolt.
Connector: speed sensor.
4. Removing the speedometer driven gear bushing and
driven gear, drain extension housing assembly fluid.
5. Remove propeller shaft (1) and mass (2).
NOTE: Apply alignment marks on the flange at both front
and rear sides.
6. Remove extension housing assembly (3) from the
vehicle.
Installation
1. Apply a thin coat of molybdenum disulfide grease to
the extension shaft spline as shown in the figure.
260RY00004
7A–98
AUTOMATIC TRANSMISSION (4L30–E)
2. Install extension housing assembly (3) to the
transmission. Tighten extension housing assembly
bolts as shown in the figure.
261RY00001
3. Install speedometer driven gear bushing and driver
gear.
4. Connect harness connectors and fuel pipe fix bolt.
Connector: speed sensor.
5. Install propeller shaft (1) and mass (2).
Torque: 63 N·m (46 lb ft)
6. Fill extension housing assembly fluid.
7. Connect battery ground cable.
7A–99
AUTOMATIC TRANSMISSION (4L30–E)
Extension Housing Assembly
Extension Housing Assembly and Associated Parts
220RY00009
Legend
(1) Speedometer Sensor, Speedometer Driven
Gear and Plate
(2) Companion Flange
(3) Extension Housing Assembly
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст