Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 262
15
11. To program more illustration press soft key.
Program more Keys!
YES
NO
12. See programming result.
Erase transponder key
1. Select Erase TP-Key mode.
2. See immobilizer status on Tech 2 screen and type security code. If the status does not allow the
programming, only immobilizer status is displayed.
3. See illustration of caution.
CAUTION: All Transponder-Keys Will Be Erased!
Confirm
Erasing Transponder-Keys
CAUTION
Erase
4. See programming result on display.
16
4. Reset Immobilizer ICU (Immobilizer Control Unit) (Gas Engine Model)
CAUTION:
Do not reset immobilizer ICU for diesel engine models.
1. Select “Body” and “Immobilizer”.
2. Select “Additional Function” and “Reset Immobilizer”.
3. Enter the security code and press Confirm.
4. Reset Immobilizer screen shows up with warning. See the following screen.
Do this only before replace the immobilizer ECU
Confirm
Reset Immobilizer
Warning: Engine will not start after reset!
5. When reset is completed, the following screen shows up.
Program completed
Confirm
17
5. Programming ICU, ECM
Program immobilizer ICU (Gas Engine Model)
1. Select “Body” and “Immobilizer”.
2. See immobilizer status on the display of Tech 2.
3. Select engine type.
4. Enter the security code.
5. See ECM status.
6. Input a program option by moving the cursor on the selection, then press Enter.
7. Select “Immobilizer installed”.
Immobilizer installed
Engine Control Module installed
Immobilizer And ECM installed
Confirm
Input Program Option
8. Input the security code, then press the soft key of “Okay” or “Not Okay”.
Security Code
0000
Press ENTER Key to continue
Not
Okay
Okay
CAUTION
9. Enter VIN.
Vehicle Identification Number:
00000000000000000
Press ENTER Key to continue
Not
Okay
Okay
Enter VIN Input Screen
18
10. Enter Mechanical key number.
Mechanical Key Number:
- - - - - - -
Press ENTER Key to continue
Not
Okay
Okay
Enter Key No. Input Screen
11. Turn ON ignition.
Ignition Status Off 0V
Turn Ignition On!
Turn On Ignition
12. See the programming result.
Tech 2 displays the result of programming as the following.
Follow those instructions.
Selected Programming is not possible due to wrong System Status!
Immobilizer Not Programmed!
Immobilizer Already Programmed!
ECM Not Programmed!
ECM Already Programmed!
13. Transponder key must be reprogrammed, because all transponder information is erased
when ICU is programmed. See Transponder programming.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст