Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1102
ELECTRICAL-BODY AND CHASSIS 8-165
HORN
Removal
1. Remove the radiator grille.
Refer to the “HEADLIGHT” removal procedure.
2. Loosen the horn bolt.
3. Disconnect the horn connector.
Installation
Follow the removal procedure in the reverse order to install the
horn.
Pay close attention to the important point mentioned in the
following paragraphs.
Connector
Be absolutely sure the horn connector is securely connected.
This will prevent a poor contact and open circuit.
1
HORN SWITCH
Removal
1. Remove the screws on the lower part of the steering wheel.
2. Remove the horn pad
1
.
3. Remove the horn wiring connector.
3
2
4. Remove the steering wheel nut
2
.
5. Remove the steering wheel
3
.
6. Remove the connector.
7. Remove the horn switch (combination switch).
Installation
Follow the removal procedure in the reverse order to install the
horn switch.
Pay close attention to the important points mentioned in the
following paragraphs.
Steering Wheel Nut
Tighten the nut to the specified torque.
Steering Wheel Nut Torque
N
⋅m (kgf⋅m/lb⋅ft)
34.3
±4.9 (3.5±0.5 / 25±3.6)
8-166 ELECTRICAL-BODY AND CHASSIS
INSPECTION AND REPAIR
Switch side
TURN SIGNAL SWITCH
Lighting Switch Connections
Terminal No.
SW position
3
4
5
Left
Neutral
Right
Turning
direction
Switch side
HAZARD WARNING FLASHER SWITCH
Hazard Warning Flasher Switch Connections
Terminal
No.
SW position
4
5
6
7
8
2
1
3
ON
OFF
ELECTRICAL-BODY AND CHASSIS 8-167
DOME LIGHT, SPOT LIGHT AND WARNING BUZZER
PARTS LOCATION (LHD)
8-168 ELECTRICAL-BODY AND CHASSIS
PARTS LOCATION (RHD)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст