Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1303
8–132 ELECTRICAL-BODY AND CHASSIS
HEADLIGHT BEAM SWITCH
Removal
1. Remove the steering wheel 1.
Refer to the “STEERING” Section of this manual.
2. Remove the Instrument panel lower cover 2.
3. Remove the steering column cover 3.
1
3
2
D08RV888
4. Disconnect the connector.
5. Remove the headlight beam switch (lever) from the
steering shaft.
D08RV747
Installation
Follow the removal procedure in the reverse order to
install the headlight beam switch (lever).
Pay close attention to the important points mentioned in
the following paragraphs.
Connector
Be absolutely sure that the headlight beam switch
connector is securely connected.
This will prevent a poor contact and an open circuit.
Wire Harness
Do not pinch the wire harnesses between the cluster and
the meter hood during the cluster installation procedure.
Wire damage will result.
ELECTRICAL-BODY AND CHASSIS 8–133
ILLUMINATION CONTROLLER
Turning the illumination controller knob upward increases
the brightness of each illumination light, turning it
downward decreases its brightness.
825RS032
Removal
1. Instrument Panel Cluster Assembly
•
Refer to Section 10 “BODY” for instrument panel
cluster assembly removal steps.
2. Illumination Controller
•
Disconnect the switch connector.
•
To remove the switch, push the lock from the back
side of the cluster assembly.
2. Illumination
controller
1. Instrument panel
cluster assembly
825RV104
Installation
To install, follow the removal procedure in the reverse
order.
Connector
Be absolutely sure that the illumination controller
connector is securely connected.
This will prevent a poor contact and an open circuit.
8–134 ELECTRICAL-BODY AND CHASSIS
AIMING OF HEADLIGHT
Check and adjust the inflation pressures, clean the
headlight lenses, park the vehicle on a level surface and
insure that vehicle is at curb weight.
VERTICAL ADJUSTMENT
Use a screwdriver for vertical adjustment.
D08RV869
HORIZONTAL ADJUSTMENT
Use a screwdriver horizontal adjustment.
D08RV868
VERTICAL ADJUSTMENT
Use a screwdriver for vertical adjustment.
D08RW433
HORIZONTAL ADJUSTMENT
Use a screwdriver horizontal adjustment.
D08RW434
ELECTRICAL-BODY AND CHASSIS 8–135
LIGHTING SWITCH
Lighting Switch Connections
15
1 2 3
7 8 9 10
16
4 5 6
12 13 14
11
OFF
PULL
MIST
OFF
HI
LO
825RV068
Terminal
SW
No.
1
7
8
position
OFF
Tail
Headlight
↔
INSPECTION AND REPAIR
Headlight Beam and Passing Switch Connections
HEADLIGHT BEAM SWITCH
15
1 2 3
7 8 9 10
16
4 5 6
12 13 14
11
825RV067
Terminal No.
16
13
15
14
SW position
At “Dimmer” position
HI
LO
At “Passing” position
C-42
Switch side
C-42
Switch side
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст