Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1302
8–128 ELECTRICAL-BODY AND CHASSIS
6. Remove the clearance light.
D08RW563
7. Remove the headlight screws.
D08RW557
8. Disconnect the headlight connector.
9. Remove the headlight.
D08RW564
ELECTRICAL-BODY AND CHASSIS 8–129
LIGHTING SWITCH
Removal
1. Remove the steering wheel 1.
Refer to the “STEERING” Section of this manual.
2. Remove the Instrument panel lower cover 2.
3. Remove the steering column cover 3.
1
3
2
D08RV888
4. Disconnect the connector.
5. Remove the lighting switch from the steering shaft.
D08RV747
Installation
Follow the removal procedure in the reverse order to
install the lighting switch.
Pay close attention to the important points mentioned in
the following paragraphs.
Installation
Follow the removal procedure in the reverse order to
install the headlight.
Pay close attention to the important points mentioned in
the following paragraphs.
Connector
Be absolutely sure that the headlight connector is
securely connected.
This will prevent a contact and an open circuit.
8–130 ELECTRICAL-BODY AND CHASSIS
Connector
Be absolutely sure that the lighting switch connector is
securely connected.
This will prevent a poor contact and an open circuit.
Wire Harness
Do not pinch the wire harnesses between the cluster and
the meter hood during the cluster installation procedure.
Wire damage will result.
CLEARANCE LIGHT
Removal
1. Remove the radiator grille. (Refer to headlight
removal procedure.)
2. Remove the side screws.
D08RV859
3. Remove the top screw.
D08RV860
4. Turn the socket counterclockwise to disconnect it
from the clearance light housing.
5. Pull the bulb from the socket.
D08RV861
ELECTRICAL-BODY AND CHASSIS 8–131
Installation
Follow the removal procedure in the reverse order to
install the clearance light.
Pay close attention to the important points mentioned in
the following paragraphs.
Connector
Be absolutely sure that the clearance light connector is
securely connected.
This will prevent a poor contact and an open circuit.
LICENSE PLATE LIGHT
Removal
1. Loosen the screws 1.
2. Remove the lens cover 2 and the lens 3.
3. Pull the bulb to remove it.
2
3
1
D08RV834
Installation
Follow the removal procedure in the reverse order to
install the license plate light.
Pay close attention to the important points mentioned in
the following paragraphs.
Bulb
Be absolutely sure that the license plate light bulb is
correctly installed.
This will prevent a poor contact and an open circuit.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст