Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1004
10-16 CAB
Important Operations
1. Power Window Switch/Window Regulator Handle
•
Prise out the power window switch and remove the
connectors.
•
To remove the regulator handle, remove the clip at the
root of the handle by using wire.
2. Bezel
•
Remove the screw while pulling the inside lever toward
you.
3. Speaker Grill
•
Pull out the clips.
4. Speaker Assembly
•
Remove 4 screws and disconnect the speaker harness
connector.
5. Door Pull Case
•
Remove the screw at the bottom of the case.
CAB 10-17
6. Door Mirror Cover
•
Pull out the upper clip, and then take out the catch at the
lower section.
7. Door Trim Pad
•
Remove the cover bottom of the trim pad (4 pcs), then
remove the screws.
8. Door Pocket
9. Power Window Box
10.Inner Waste Seal
11.Door Mirror Assembly
•
Remove 3 fixing bolts and then remove the connector.
12.Outer Waste Seal
13.Door Mirror Bracket
•
Remove 2 bolts at the lower section, and then remove 2
screws in the weather strip.
14.Bracket
15.Speaker Box
•
Remove 3 fixing bolts.
16.Water Proof Sheet
•
Take care not to damage the sheet when peeling it off.
10-18 CAB
17.Window Glass
•
Remove 2 screws through the access hole and pull out
the window glass upward.
18.Window Regulator/Power Window Motor
•
Disconnect the power window motor connector.
19.Glass Run
•
Pull it out of the door piller of the channel. (front/rear)
20.Glass Run Rear Channel
•
Remove 2 screws.
21.Inside Lever
22.Door Lock Assembly/Door Lock Actuator
•
Disconnect the linkage with the outside handle, the
inside lever and the lock cylinder.
23.Glass Run Front Channel
24.Door Lock Cylinder
•
Remove the door lock cylinder by applying finger
pressure from inside while depressing the retaining clip.
25.Outside Handle
CAB 10-19
DISASSEMBLY AND REASSEMBLY
(Rear Door)
Disassembly Steps
V
1. Power window switch/Window regurator
handle
V
2. Bezel/Speaker grill
3. Inside pull handole/Speaker
V
4. Door trim pad
5. Arm rest (W/Power window only)
6. Water proof sheet
7. Glass guide
8. Upper cover
V
9. Window regurator/Power window motor
V
10. Window glass
11. Bracket
12. Inside lever
13. Outside handle
V
14. Door lock cylinder
15. Outer waste seal
16. Glass run
Reassembly Steps
To reassemble, follow the disassembly steps
in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст