Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 600
ENGINE ELECTRICAL 6D – 7
SYMBOLS AND ABBREVIATIONS
DESCRIPTION
The symbols and abbreviations used in the circuit diagram
make the diagram easier to read and understand.
SYMBOLS
The illustration at the left shows a typical symbol
used
in circuit diagrams.
Refer to the following table.
SYMBOL AND MEANING
Symbol Meaning Symbol Meaning
Fuse
Single filament bulb
Main fuse
Double filament bulb
Fusible link wire
Motor
Switch
Variable resistor
Switch
Coil (Inductor)
6D – 8 ENGINE ELECTRICAL
Symbol Meaning Symbol Meaning
Contact wiring
Battery
Relay
Note:
Relay contact shown in the
wiring diagram indicates
condition before actuation.
Diode
Connector
Electronic part
Light emitting diode
Resistor
Reed switch
Speaker
Condenser
ABBREVIATIONS
The illustration at the left shows a typical abbreviation
used in circuit diagrams.
These same abbreviations may also appear in the next.
Refer to the following table.
ABBREVIATION AND MEANING
Abbreviation Meaning Abbreviation Meaning
RH
LH
SW
M/T
A/T
FT
RR
FLW
TEMP
ECM
Right-hand side
Left-hand side
Switch
Manual transmission
Automatic transmission
Front
Rear
Fusible link wire
Temperature
Electronic control module
STD
OPT
W/
WO/
OD
ACC
A/C
ATF
VSV
Standard equipment
Optional equipment
With
Without
Overdrive
Accessories
Air conditioner
Automatic transmission fluid
Vacuum switching valve
ENGINE ELECTRICAL 6D – 9
TORQUE SPECIFICATIONS
GENERATOR
kg
m(ft. lbs/N m)
STARTER MOTOR
kg
m(ft. lbs/N m)
0.65
±±±± 0.5(4.7 ±±±± 3.6/6.3 ±±±± 4.9)
6D – 10 ENGINE ELECTRICAL
GENERATOR
REMOVAL AND INSTALLATION
Read this Section carefully before performing any removal and installation procedure. This Section gives you
important points as well as the order of operation. Be sure that you understand everything in this Section before you
begin.
Important Operations-Removal
Cooling Fan Belt
1) Disconnect the battery cables at the battery terminals.
2) Loosen and remove the fan belt adjusting plate bolts.
3) Remove the fan belt from the generator drive pulley.
Generator
Remove the generator bolt and the generator from the
bracket.
Important Operations-Installation
Follow the removal procedure in the reverse order to
perform the installation procedure. Pay careful attention to
the important points during the installation procedure.
Generator
1) Install the generator to the bracket.
2) Tighten the generator bolt to the specified torque.
Generator Bolt Torque
kg·m (lb·ft/N·m)
1.9
± 0.5 (13.7 ± 3.6/18.6 ± 4.9)
4.1
± 0.6 (29.6 ± 4.3/40.2 ± 5.9)
066L200001
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст