Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1409
ELECTRICAL-BODY AND CHASSIS 8-201
CIRCUIT DIAGRAM (RHD)
8-202 ELECTRICAL-BODY AND CHASSIS
ELECTRICAL-BODY AND CHASSIS 8-203
TROUBLE SHOOTING
CIGARETTE LIGHTER
1. Lighter does not pop out after being pushed in. It does not become hot.
Checkpoint
Trouble Cause
Countermeasure
Reinstall or replace the fuse
No. CB-20 (15A)
Poor Fuse No. CB-20 (15A,
Fuse box) contact or blown
NG
Replace the lighter
Lighter continuity between
center part and outer area
Open circuit or poor connector
contact
Repair open circuit or
connector contact
Voltage between connector 1
B-21
and the ground at
starter SW. is ACC position
(Should be battery voltage
present)
Open circuit or poor connector
contact
NG
NG
OK
OK
OK
Audio system (System should
receive power)
Repair open circuit or
connector contact
Open circuit or poor connector
contact
NG
Continuity between connector
1
B-22
and the ground
2. Lighter pops out prematurely before becoming hot
Repair or replace the lighter
and/or casing
Deformed lighter or casing
NG
Lighter and casing
3. Lighter becomes too hot
Repair or replace the lighter
and/or casing
Deformed lighter and casing
NG
Lighter and casing
8-204 ELECTRICAL-BODY AND CHASSIS
REMOVAL AND INSTALLATION
AUDIO
Refer to Section 9 “ACCESSORIES” for details.
CIGARETTE LIGHTER
Removal
1. Remove the lighter
1
.
2. Disconnect the connector
2
.
3. Loosen the lighter holder
3
nut at the back side.
4. Remove the holder from the bezel.
Installation
Follow the removal procedure in the reverse order to install the
lighter.
Pay close attention to the important points mentioned in the
following paragraphs.
Connector
Be absolutely sure that the lighter connector is securely
connected.
This will prevent a poor contact and an open circuit.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст