Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1310
8–160 ELECTRICAL-BODY AND CHASSIS
REAR COMBINATION LIGHT
Back Up Light
Removal
1. Open the rear gate.
2. Remove the screws.
3. Remove the rear combination light assembly.
D08RV751
4. Turn the bulb 3 counterclockwise to remove it.
3
D08RV886
Installation
Follow the removal procedure in the reverse order to
install the rear combination light.
Pay close attention to the important points mentioned in
the following paragraphs.
Bulbs
Be absolutely sure that each bulb is correctly installed.
This will prevent a poor contact and an open circuit.
ELECTRICAL-BODY AND CHASSIS 8–161
HAZARD WARNING FLASHER SWITCH
Removal
1. Instrument Panel Cluster Assembly
•
Refer to Section 10 “BODY” for instrument panel
cluster assembly removal steps.
2. Hazard Warning Switch
•
Disconnect the switch connector.
•
To remove the switch, push the lock from the back
side of the cluster assembly.
D08RV893
Installation
To install, follow the removal procedure in the reverse
order.
Connector
Be absolutely sure that the hazard warning flasher switch
connector is securely connected.
This will prevent a poor contact and an open circuit.
BACK UP LIGHT SWITCH
Removal
1. Disconnect the connector 1.
2. Remove the back up light switch from the
transmission
2.
1
2
D08RV867
Installation
Follow the removal procedure in the reverse order to
install the back up light switch.
Pay close attention to the important points mentioned in
the following paragraphs.
8–162 ELECTRICAL-BODY AND CHASSIS
Connector
Be absolutely sure that the back up light connector is
securely connected.
This will prevent a poor contact and an open circuit.
Back up Light Switch Threads
Apply liquid gasket to the threaded portion and install the
back up light switch.
HORN
Removal
1. Remove the radiator grille.
Refer to the “HEADLIGHT” removal procedure.
2. Loosen the horn bolt.
3. Disconnect the horn connector.
D08RV878
Installation
Follow the removal procedure in the reverse order to
install the horn.
Pay close attention to the important points mentioned in
the following paragraphs.
Connector
Be absolutely sure that the horn connector is securely
connected.
This will prevent a poor contact and an open circuit.
ELECTRICAL-BODY AND CHASSIS 8–163
HORN SWITCH
Removal
1. Remove the horn pad 1.
1
D08RV870
2. Remove the steering wheel nut 2.
3. Remove the steering wheel 3.
4. Remove the horn switch.
2
3
D08RV871
Installation
Follow the removal procedure in the reverse order to
install the horn switch.
Pay close attention to the important points mentioned in
the following paragraphs.
Steering Wheel Nut (2)
Tighten the nut to the specified torque.
Steering Wheel Nut Torque
kg·m (lb·ft/N·m)
3.5 ± 0.5 (25.3 ± 3.6/34.3 ± 4.9)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст