Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1585
2A-32 FRAME AND BUMPER
SECT K-K
FRAME AND BUMPER 2A-33
VIEW A (Except Australia)
For Crew Cab
SHEET METAL 2B-1
SECTION 2B
SHEET METAL
TABLE OF CONTENTS
PAGE
Removal and installation . . . . . . . . . . . . . . . . . . . . . . . . .. 2B- 1
Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2B- 4
REMOVAL AND INSTALLATION
1
2
3
4
5
6
7
8
Removal Steps
Installation Steps
Engine Hood
Fender
V
1. Bolt
11. Fender
2. Engine hood assembly
10. ECM box (Driver side)
Fender
9. Antenna cable (Passenger side)
3. Combination lamp connector
8. Steering lower cover or speaker grille
V
4. Radiator grille
7. Inner liner
5. Bumper assembly
6. Combination lamp
V
6. Combination lamp
5. Bumper assembly
V
7. Inner liner
4. Radiator grille
8. Steering lower cover or speaker grille
3. Combination lamp connector
9. Antenna cable (Passenger side)
Engine Hood
10. ECM box (Driver side)
2. Engine hood assembly
V
11. Fender
1. Bolt
2B-2 SHEET METAL
Important Operations - Removal
1. Bolt
Before removing the hinges from the engine hood, scribe a
mark showing location of the hinges to facilitate installation in
the original position.
1
4. Radiator Grille
Remove the radiator grille center screw
1
.
(ONE POINT)
Use a screwdriver to raise the clip
2
and release the lock.
Place a clean rag beneath the screwdriver tip to protect the
body painted surfaces. (EIGHT POINTS)
Remove the radiator grille
3
.
6. Combination Lamp
Remove the combination lamp fixing screws.
1
Turn the socket
1
counterclockwise to disconnect it from the
marker light housing.
Pull the bulb from the socket.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст