Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 939
PROPELLER SHAFT 4A-11
Play in the Splines in the Normal
Direction of Rotation
Check the amount of play in the sleeve yoke and the propeller
shaft splines in the direction of rotation using a pointed feeler
gauge.
mm(in)
Standard
Limit
0.06 - 0.14
0.3 (0.012)
(0.002 - 0.006)
Play in Spider Bearing
(1) Check the spider bearings for wear or damage.
(2) Check the amount of axial and radial play in spider bearing
by moving the yoke back and forth on the spider axes and
shaft axis.
mm(in)
Limit
0.5 (0.02)
If the limit is exceeded, replace the shaft assembly.
4A-12 PROPELLER SHAFT
REASSEMBLY
UNIVERSAL JOINT
Disassembly steps
1. Flange yoke
2. Spider
3. Needle roller bearing
4. Snap ring
Reassembly steps
To reassemble, follow the disassembly steps
in the reverse order.
REASSEMBLY
1. Flange yoke
2. Spider
•
Be sure to install the spider by aligning the setting marks
made during disassembly.
3. Needle Roller Bearing
1) Apply a molybdenum-disulfide grease or a multi-purpose.
type grease NLGI No.2 to inside of the bearing cap.
Grease Amount
g(oz)
Approx. 1.2 (0.042)
PROPELLER SHAFT 4A-13
2) Using either a mallet (or copper hammer) or a press, install
the needle roller bearing into the yoke so that snap ring can
be installed in its groove.
CAUTION:
•
The needle roller bearing cannot be installed smoothly
if it is set at an incorrect angle with the flange.
•
Excessive hammering will damage the needle roller
bearing.
3) Align setting marks and join the yokes.
NOTE:
Assemble the spider and spline yoke so that their grease
fittings are arranged on the same side.
4. Snap ring
NOTE:
Discard used snap rings and install new ones.
When the bearing cap is in position, select and attach a snap
ring of suitable thickness so that the end play of the spider pin
is held within 0.1mm (0.004in).
mm(in)
Snap ring thickness
Identification color
1.5
(0.059)
Blue
1.53
(0.060)
White
1.59
(0.063)
Yellow
1.62
(0.064)
Green
1.68
(0.066)
Not colored
NOTE:
Be sure to use snap rings of the same thickness on both sides.
4A-14 PROPELLER SHAFT
CAUTION:
There are two types of snap rings on the Transmission
side joints. And there is no interchangeability between
them, so be sure not to misassemble them.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст