Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual — part 1718
6F-8 ENGINE EXHAUST
Front Exhaust Pipe
Front Exhaust Pipe and Associated Parts
(2.2L & 2.0L Models)
Legend
1 Front Exhaust Pipe Fixing Nuts
2 O
2
Sensor (If applicable)
3 Front Exhaust Pipe
4 Front Exhaust Pipe Fixing Bolts and Nuts
(2.4L Model)
Legend
1 Front Exhaust Pipe Fixing Nuts
2 O
2
Sensor (If applicable)
3 Front Exhaust Pipe
ENGINE EXHAUST 6F-9
Removal
(2.2L & 2.0L)
1. Disconnect battery ground cable.
2. Raise the vehicle and support with suitable safety stands.
3. Disconnect O
2
sensor harness connector and remove front
side O
2
sensor (2). (If applicable)
4. Remove front exhaust pipe fixing bolts and nuts (4).
5. Remove front exhaust pipe fixing four stud nuts from
exhaust manifold (1).
6. Remove front exhaust pipe (3)
(2.4L)
1. Disconnect battery ground cable.
2. Raise the vehicle and support with suitable safety stands.
3. Remove the exhaust silencer.
4. Remove mid pipe.
5. Remove the propeller shaft assy.
6. Remove the O
2
sensor.
7. Remove front exhaust pipe.
Installation
1. Install front exhaust pipe (3) and tighten four stud nuts.
Torque:
Stud Nuts: 28 N
⋅⋅⋅⋅m (2.9 kgf⋅⋅⋅⋅m)
Nuts: 43 N
⋅⋅⋅⋅m (4.4 kgf⋅⋅⋅⋅m)
2. Tighten front side O
2
sensor and reconnect O
2
sensor
harness connector. (If applicable)
Torque:55 N
⋅⋅⋅⋅m (5.6 kgf⋅⋅⋅⋅m)
6F-10 ENGINE EXHAUST
Mid Pipe
Mid Pipe and Associated Parts
Legend
1. Front Exhaust Pipe Fixing Nuts
2. Mid Pipe Fixing Bolts
3. Mid Exhaust Pipe Mounting Rubber
4. Mid Pipe
ENGINE EXHAUST 6F-11
(2.4L Model)
Legend
1. Front Exhaust Pipe Fixing Nuts
2. O
2
Sensor
3. Front Exhaust Pipe
Removal
(2.2L & 2.0L)
1. Disconnect battery ground cable.
2. Raise the vehicle and support with suitable safety stands.
3. Remove front exhaust pipe fixing bolts and nuts (1).
4. Remove mid pipe fixing four stud nuts from Catalytic
Convertor.
5. Remove mid pipe (4)
(2.4L)
1. Disconnect battery ground cable.
2. Raise the vehicle and support with suitable safety stands.
3. Remove exhaust silencer.
4. Remove mid pipe.
Installation
1. Install center exhaust pipe (4) and tighten four fixing bolts
(2) and two bolts and nuts (1) to the specified torque:
Torque:
Fixing bolts: 43 N
⋅⋅⋅⋅m (4.4 kgf⋅⋅⋅⋅m)
Bolts: 43 N
⋅⋅⋅⋅m
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст