Isuzu KB P190. Manual — part 1282
8A-190 ELECTRICAL-BODY AND CHASSIS
REAR FOG LIGHT
PARTS LOCATION (RHD)
RTW78AXF037101 & RTW78AXF043301
ELECTRICAL-BODY AND CHASSIS 8A-191
PARTS LOCATION (LHD)
RTW78AXF037201 & RTW78AXF043401
8A-192 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM 4JJ1-TC/4JK1-TC (LHD) G.EXP
RTW78AXF023101
ELECTRICAL-BODY AND CHASSIS 8A-193
RTW48ASH000701
REAR FOG LIGHT
Removal
1. Remove the screws
1
.
2. Remove the lens cover
2
.
3. Rear fog push turn the bulb
3
counterclockwise to
disconnect it from the light housing.
Installation
Follow the removal procedure in the reverse order to install the
rear fog light.
Pay close attention to the important points mentioned in the
following paragraphs.
Bulb
Be absolutely sure that the license plate light bulb is correctly
installed.
This will prevent a poor contact and open circuit.
RTW78ASH000401
FRONT FOG & RR FOG SWITCH
RTW48ASH000401
Inspection
Check to see if there is any continuity between the terminals of
the leveling switch.
Replace the switch when the result of inspection is found
abnormal.
Removal
Preparation:
Disconnect the battery ground cable.
1. Ventilation grille
2. Harness connector
3. Front fog light & Rear fog light switch
To remove the switch, push the lock from the back side of
the cluster assembly.
4. Remove the bulb.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст