Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 446
LIGHTING SYSTEM
8A–5
6. Turn the headlight low beam on.
7. Adjust the CUTLINE 30 mm (1.18 in) below the
horizontal line (H).
801R200011
Vertical Adjustment
Use a screwdriver for vertical adjustment.
801R200012
8A–6
LIGHTING SYSTEM
Side Marker Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the front combination light (1).
D
Remove the screw.
3. Remove the bulb (2).
D
Remove the side marker light socket (3) by turning it
counterclockwise.
D
Remove the bulb by turning it counterclockwise
while pushing it at the same time.
801R200013
Installation
To install, follow the removal steps in the reverse order.
LIGHTING SYSTEM
8A–7
Taillight Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the rear combination light assembly (1).
D
Remove two screws.
D
Pull out the rear combination light assembly
outside.
803R200011
3. Remove the bulb (1).
D
Remove the taillight socket by turning it
counterclockwise.
D
Remove the bulb by turning it counterclockwise
while pushing it at the same time.
803R200002
Installation
To install, follow the removal steps in the reverse order.
8A–8
LIGHTING SYSTEM
License Plate Light Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove the license plate light garnish.
D
Remove the three screws.
3. Remove the lens cover (3).
D
Remove two screws.
4. Remove the license plate light socket by turning it
counterclockwise.
5. Remove the bulb (2).
D
Pull out the bulb from the socket (1).
803R200003
Installation
To install, follow the removal steps in the reverse order.
Stoplight Bulb
Removal and Installation
Refer to
Taillight Bulb in this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст