Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 449
LIGHTING SYSTEM
8A–17
Starter Switch
Removal and Installation
Refer to
Lock Cylinder in Steering section.
Lighting Switch (Combination Switch)
Removal and Installation
Refer to
Combination Switch in Steering section.
Dimmer·Passing Switch (Combination Switch)
Removal and Installation
Refer to
Combination Switch in Steering section.
Front Door Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the door switch (2).
D
Remove the screw (3).
D
Disconnect the connector (1).
825R200038
Installation
To install, follow the removal steps in the reverse order.
8A–18
LIGHTING SYSTEM
Rear Door Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the door switch (2).
D
Remove the screw (3).
D
Disconnect the connector (1).
825R200039
Installation
To install, follow the removal steps in the reverse order.
Tailgate Lock Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the tailgate outside handle.
D
Refer to
Tail Gate Outside Handle in Security and
Locks section.
3. Remove the tail gate lock switch (1).
D
Disconnect the switch connector (2) and lock
actuator connectors (3).
825R200031
Installation
To install, follow the removal steps in the reverse order.
LIGHTING SYSTEM
8A–19
Key Remind Switch (Starter Switch)
Removal and Installation
Refer to
Lock Cylinder in Steering section.
Hazard Warning Light Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the center cluster assembly (1).
D
Refer to
Instrument Panel Assembly in Body
Structure section.
3. Remove the hazard warning switch (2).
D
Disconnect the switch connector.
D
To remove the switch, push the lock from the back
side of the center cluster assembly.
825R200026
Installation
To install, follow the removal steps in the reverse order.
8A–20
LIGHTING SYSTEM
Stoplight Switch
Removal and Installation
Refer to
Stoplight Switch in Brake section.
Turn Signal Light Switch (Combination Switch)
Removal and Installation
Refer to
Combination Switch in Steering section.
Illumination Controller
Removal
1. Disconnect the battery ground cable.
2. Remove the meter cluster panel cover assembly (2).
D
Refer to
Instrument Panel Assembly in Body
Structure section.
3. Remove the illumination controller (1).
D
Disconnect the controller connector.
D
Remove the controller knob (4).
D
Remove the nut (3).
D
Remove the controller from the back side of the
meter cluster panel assembly.
825R200027
Installation
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст