Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Manual — part 540
1A–28 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Adjust the control cable.
865RY00013
D
Air source control cable.
1. Slide the control lever to the left (“CIRC”
position).
2. Connect the control cable at the “CIRC” position
of the link unit of the blower assembly and
secure it with the clip.
D
Temperature control cable.
1. Turn the control knob to the left (“MAX COLD”
position).
2. Connect the control cable at the “COLD”
position of the temperature control link of the
heater unit and secure it with the clip.
D
Air select control cable
1. Turn the control knob to the right (“DEFROST”
position).
2. Connect the control cable at the “DEFROST”
position of the mode control link of the heater
unit and secure it with the clip.
2. Check the control cable operation.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–29
Control Panel Illumination Bulb
Control Panel Illumination Bulb and Associated Parts
865RS007
Legend
(1) Control Lever Assembly
(2) Bulb Socket
(3) Illumination Bulb
Removal
1. Disconnect the battery ground cable.
2. Remove control lever assembly.
D
Refer to Control Lever Assembly in this section.
3. Pull out the bulb socket from the panel by turning it
counterclockwise.
4. Pull the illumination bulb from the socket.
Installation
To install, follow the removal steps in the reverse order.
1A–30 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
Resistor
Resistor and Associated Parts
874RW005
Legend
(1) Glove Box
(2) Duct (Heater only)
(3) Resistor Connector
(4) Resistor
(5) Front Console
(6) Lower Cluster
(7) Instrument Panel Passenger Lower Cover
Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove front console.
3. Remove lower cluster.
4. Remove glove box.
5. Remove instrument panel passenger lower cover
assembly.
D
Refer to Instrument Panel Assembly in Body and
Accessories section.
6. Remove resistor connector.
7. Remove duct (heater only).
8. Remove resistor.
Installation
To install, follow the removal steps in the reverse order.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–31
Air Conditioning System
General Description
Air Conditioning Refrigerant Cycle Construction
C01RS003
Legend
(1) Electronic Thermostat
(2) Evaporator Core
(3) Evaporator Assembly
(4) Temperature Sensor
(5) Expansion Valve
(6) Blower Motor
(7) Dual Pressure Switch
(8) Receiver/Drier
(9) Condenser
(10) Compressor
(11) Magnetic Clutch
(12) Mode (HEAT) Control Door
(13) Temp. Control Door (Air Mix Door)
(14) Heater Core
(15) Mode (VENT) Control Door
(16) Heater Unit
(17) Mode (DEF) Control Door
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст