Nissan Almera Tino V10. Manual — part 195
AT-504
[ALL]
ASSEMBLY
10. Tighten side cover fixing bolts to specified torque.
●
Do not mix bolts A and B.
●
Always replace bolts A as they are self-sealing bolts.
Assembly (2)
ECS009CW
1.
Remove paper rolled around bearing retainer.
2.
Install thrust washer on bearing retainer.
●
Apply petroleum jelly to thrust washer.
3.
Install forward clutch assembly.
●
Align teeth of low & reverse brake drive plates before
installing.
●
Make sure that bearing retainer seal rings are not spread.
4.
Install thrust needle bearing on bearing retainer.
●
Apply petroleum jelly to thrust bearing.
●
Pay attention to direction of thrust needle bearing.
SAT124E
SAT354D
SAT355D
SAT356D
ASSEMBLY
AT-505
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
5.
Install thrust needle bearing on rear internal gear.
●
Apply petroleum jelly to thrust needle bearing.
●
Pay attention to direction of thrust needle bearing.
6.
Hold forward clutch hub and turn overrun clutch hub.
Check overrun clutch hub for directions of lock and unlock.
●
If not as shown in illustration, check installed direction of for-
ward one-way clutch.
7.
Install rear internal gear assembly.
●
Align teeth of forward clutch and overrun clutch drive
plate.
8.
Install needle bearing on rear planetary carrier.
●
Apply petroleum jelly to needle bearing.
●
Pay attention to direction of needle bearing.
9.
Install rear sun gear on rear planetary carrier.
●
Pay attention to direction of rear sun gear.
SAT357D
SAT358D
SAT359D
SAT360D
SAT052D
AT-506
[ALL]
ASSEMBLY
10. Install rear planetary carrier on transmission case.
11. Install thrust needle bearing on front planetary carrier.
●
Apply petroleum jelly to thrust needle bearing.
●
Pay attention to direction of thrust needle bearing.
12. Install low one-way clutch to front planetary carrier by turning it
in the direction of the arrow as shown.
13. While holding front planetary carrier, turn low one-way clutch.
Check low one-way clutch for correct directions of lock and
unlock.
14. Install front planetary carrier assembly on transmission case.
15. Install snap ring with screwdriver.
●
Forward clutch and bearings must be correctly installed
for snap ring to fit groove of transmission case.
SAT362D
SAT363D
SAT048D
SAT047D
SAT046D
ASSEMBLY
AT-507
[ALL]
D
E
F
G
H
I
J
K
L
M
A
B
AT
16. Install needle bearing on front sun gear.
●
Apply petroleum jelly to needle bearing.
●
Pay attention to direction of needle bearing.
17. Install front sun gear on front planetary carrier.
18. Install needle bearing on front sun gear.
●
Apply petroleum jelly to needle bearing.
●
Pay attention to direction of needle bearing.
19. Install high clutch hub on front sun gear.
20. Install needle bearing on high clutch hub.
●
Apply petroleum jelly to needle bearing.
●
Pay attention to direction of needle bearing.
SAT367D
SAT368D
SAT369D
SAT370D
SAT371D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст