Nissan Almera Tino V10. Manual — part 608
EC-1258
[YD (WITHOUT EURO-OBD)]
PRECAUTIONS
●
After performing each TROUBLE DIAGNOSIS, perform DTC
Confirmation Procedure or Overall Function Check.
The DTC should not be displayed in the DTC Confirmation
Procedure if the repair is completed. The Overall Function
Check should be a good result if the repair is completed.
●
When measuring ECM signals with a circuit tester, never
allow the two tester probes to contact.
Accidental contact of probes will cause a short circuit and
damage the ECM power transistor.
●
Do not use ECM ground terminals when measuring input/
output voltage. Doing so may result in damage to the ECM's
transistor. Use a ground other than ECM terminals, such as
the ground.
●
Do not disassemble fuel pump.
If NG, take proper action.
●
Do not disassemble fuel injector.
If NG, replace fuel injector.
●
Do not depress accelerator pedal when staring.
●
Immediately after staring, do not rev up engine unnecessar-
ily.
●
Do not rev up engine just prior to shutdown.
●
When installing C.B. ham radio or a mobile phone, be sure
to observe the following as it may adversely affect elec-
tronic control systems depending on installation location.
–
Keep the antenna as far as possible from the electronic
control units.
–
Keep the antenna feeder line more than 20 cm (8 in) away
from the harness of electronic controls.
Do not let them run parallel for a long distance.
–
Adjust the antenna and feeder line so that the standingwave
radio can be kept smaller.
–
Be sure to ground the radio to vehicle body.
SAT652J
SEF348N
SEF709Y
SEF708Y
PRECAUTIONS
EC-1259
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
Wiring Diagrams and Trouble Diagnosis
EBS014S9
When you read Wiring diagrams, refer to the following:
●
GI-11, “HOW TO READ WIRING DIAGRAM”
●
EL-11, “POWER SUPPLY ROUTING” for power distribution circuit
When you perform trouble diagnosis, refer to the following:
●
GI-32, “How to Follow Test Groups in Trouble Diagnoses”
●
GI-21, “HOW TO PERFORM EFFICIENT DIAGNOSES FOR AN ELECTRICAL INCIDENT”
EC-1260
[YD (WITHOUT EURO-OBD)]
PREPARATION
PREPARATION
PFP:00002
Special Service Tools
EBS014SA
Commercial Service Tools
EBS014SB
Tool number
Tool name
Description
EG17650301
Radiator cap tester
adapter
Adapting radiator cap tester to radiator cap and
radiator filler neck
a: 28 (1.10) dia.
b: 31.4 (1.236) dia.
c: 41.3 (1.626) dia.
Unit: mm (in)
KV109E0010
Break-out box
Measuring the ECM signals with a circuit tester
KV109E0080
Y-cable adapter
Measuring the ECM signals with a circuit tester
S-NT564
S-NT825
S-NT826
Tool name
Description
Socket wrench
Removing and installing engine coolant
temperature sensor
S-NT705
ENGINE CONTROL SYSTEM
EC-1261
[YD (WITHOUT EURO-OBD)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
ENGINE CONTROL SYSTEM
PFP:23710
System Diagram(YD22DDTi Engine Models)
EBS014SC
MBIB0608E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст